Bedding can be unzipped and removed for washing. Machine wash cold water, gentle cycle, and air dry or tumble dry on low or no heat. Iron on lowest setting for polyester/cotton. Secure all snaps/straps/tabs before washing. White Sheets (2/pack) are Badger Basket Model #31003.
Page 3
• FALL HAZARD—Always check that the bassinet is securely locked on the base/stand by pulling upwards on the bassinet bed. • Use ONLY the bedding designed for this bassinet from Badger Basket®. Secure the bedding as instructed in this manual and check regularly to ensure it remains properly attached.
Page 4
A×2 B×1 C×1 BODY CANOPY D×1 E×1 F×1 BODY WITH FOAM BASKET FITTED SHEET PADDING G×1 H×1 I×1 Does not apply to all models. Only applies to bedding sets with belt loops on the liner around the top rim of the bassinet.
Page 5
DO NOT REMOVE THE FOAM PADDING FROM THE METAL FRAME. THIS IS INTENTIONAL, IS A VITAL PART OF THE BASSINETS FRAME AND IS NOT PACKING MATERIAL. Unfold the BODY (B) and attach both of the LEGS (A). The wheels rotate and can be locked in the cradle position (the bassinet will rock) or in the bassinet position (the bassinet is stationary).
Page 6
Turn the BODY(B) right side up. Secure the BASKET (D) to the BODY (B). Unfold the LINER/SKIRT (I) and position it on the frame. Then zip all of the zippers around the top rim of the bassinet on all sides around the BODY (B). Back Side Make sure insert pin is inserted fully into the retaining...
Page 7
“WARNING: Make sure that ALL 8 red safety snaps are secured after the zippers are properly zipped” Insert the BOTTOM (G). Push the clips through the holes in the fabric. Position the clips on the outside.Then apply pressure to BOTH SIDES of the BOTTOM (G) on the inside at the same time to snap the clips into place.
Page 8
Put the FITTED SHEET (F) onto the VINYL/FOAM PAD (E) and insert into the BODY (B). Fully insert the CANOPY (C) posts into the clips on the BODY (B). IF APPLICABLE TO YOUR MODEL: Thread the BELT (H) through the belt loops on the LINER/SKIRT (I) and tie the ends into a bow.
Need help?
Do you have a question about the 31001 and is the answer not in the manual?
Questions and answers