Please read the important notice before the installation.
1. Installing VideoCAM NB 300 software
A. Insert the VideoCAM NB 300 software CD into CD-ROM drive.
B.
After few seconds, the setup screen will show the picture of
VideoCAM NB 300. Click the "Utility Driver" then simply follow
the on-screen instructions.
C.
Please remember to install DirectX of the CD-ROM.
Notice:
If the setup screen doesn't show the picture of VideoCAM NB
300, please proceed the following installation:
Go to the taskbar and click Start then Execute.
Type D:\SETUP.EXE , then click Enter
key.
(Suppose your CD-ROM is in Drive D)
2. Connect the VideoCAM NB 300 to your
computer.
Connect the VideoCAM NB 300 to the USB port as
shown on the right drawing.
3. To get rid of driver installation, please go to t
follow "Start
VideoCAM NB 300 Uninstall, then follow the on-screen
instruction to remove the installation.
4. You can install the recognize software for video conferencing
or chat with your friends.
I mportant Notice:
Please install the driver first and then
c
onnect VideoCAM NB 300 to the USB
p
ort.
Program
1
USB Port
he taskbar and
VideoCAM NB 300
English
Need help?
Do you have a question about the VideoCAM NB 300 and is the answer not in the manual?
Questions and answers