2022-up polaris rzr pro r turn signal kit with horn (8 pages)
Summary of Contents for SSV Works SWITCH WORKS TANGO 2 230-SWTS-PN3
Page 1
230-SWTS-PN3 2013-2018 Honda Pioneer Turn Signal Kit with Horn SSV WORKS, 201 N. Rice Ave Unit A, Oxnard, CA 93030 www.SSVworks.com Phone: 818-991-1778 Fax: 866-293-6751 WARRANTY INFORMATION: Please read and understand these All SWITCH Works Electronics are covered by a limited 1 year warranty against defects instructions completely before in material or workmanship.
Page 2
SWTS-PN3 SWITCH Works Tango2 Parts List Tango2 Turn Signal Module Tango2 Turn Signal Rocker Tango2 Turn Signal Main Switch Harness [B-H3271] Front Turn Signal Extension Honda Pioneer Rear Turn Signal Tango2 Front Turn Signal LED Harness (x2) [B-S2959] Harness [B-H3205] Lamps (x2) [B-H2813] Zip Ties (x10) Power Input Harness...
Page 3
SWTS-PN3 SWITCH Works TANGO2 Honda Pioneer Turn Signal Kit Wiring Diagram Description Part # Tango2 Turn Signal Module Tango2 Turn Signal Rocker Switch Tango2 Turn Signal Main Harness B-H3271 Power Connector to Busbar Pulse Connector Power Input Harness, 3 ft. B-H3413 Front Turn Signal Extension Harness (x2) B-H2959...
SWTS-PN3 TOOLS NEEDED FOR INSTALLATION - Phillips Screw Driver - Drill - 3/4” Hole Saw A. Remove the hood panel by unlocking the 2 hood lock latches. B. Lift and gently pull the dash cover away from the vehicle to expose the battery.
Page 5
SWTS-PN3 E. Route the front left and right turn signal extension cables to the F. Run the TANGO2 rear turn signal harness (B-H3205) to the rear of front of the vehicle. Make sure to route the correct cable connector the vehicle. Use zip ties to secure the cable away from any moving end that will plug to the LED lamp.
Page 6
SWTS-PN3 K. Horn mounting recommendations: 1. Mount away from moving parts; L. Unplug the factory tail light connector and plug it to the “PASS. 2. Mount as high as possible; 3. Mount with the horn facing downward INPUT” connector of the Honda Pioneer Rear Turn Signal Harness to protect from water damage.
Page 7
SWTS-PN3 Q. Plug the 3-pin connector of the Power Input Harness (B-H3413) to R. Run the BATT and GND wires of the Power Input Harness (B-H3413) the Honda Pioneer Turn Signal Main harness (B-H3271). to the battery and screw in the ring terminals to the. RETAINER 12 V ACCESSORY ACCESSORY PORT...
Page 8
SWTS-PN3 Turn Signal 180 Degree Viewing Angle Turn signal light should be viewable at a 180 angle from the front and rear of the vehicle. TURN SIGNAL ROCKER SWITCH FUNCTIONS Momentary Press = Horn Button Momentary Press = Left turn signal with 8-flash auto turn off Press and Hold (1 sec) = Left turn signal continuous flashing / Press again to turn off Momentary Press =...
Need help?
Do you have a question about the SWITCH WORKS TANGO 2 230-SWTS-PN3 and is the answer not in the manual?
Questions and answers