Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Lambrecht PROFESSIONAL-IX 3.0
Summary of Contents for Lambrecht PROFESSIONAL-IX 3.0
- Page 1 USER MANUAL PROFESSIONAL-IX 3.0 Wind Sensors...
-
Page 2: Table Of Contents
LAMBRECHT meteo | PROFESSIONAL-IX 3.0 Contents Features of the PROFESSIONAL-IX 3.0 Warranty Introduction Setting to work General installation conditions Tools and installation material Unpacking the sensor Incoming goods inspection Energy supply Installation Mast or pipe mounting Mounting on traverse with slotted borehole... -
Page 3: Features Of The Professional-Ix
Damage that can be attributed to operation of the devices outside the specified conditions of use. Introduction PROFESSIONAL-IX 3.0 is a very robust, compact, and extremely reliable wind sensor. The system is specially designed for use under extremely low temperatures. The wind sensors acquire the horizontal air flow and processes the measured data into the meteorological parameters wind speed or wind direction. -
Page 4: General Installation Conditions
The sensor pair PROFESSIONAL-IX 3.0 with its arrangement of sensors next to each other easily meets this requirement. The sensor must not be installed onto transmitting plants or antennas or close to them. A minimum distance of 2 m is to be kept for interference-free signal transfer. -
Page 5: Energy Supply
4.5 Energy supply The sensor requires a 24 volt nominal DC power source (20…28 VDC) for operation. The heating of the PROFESSIONAL-IX 3.0 has to be supplied with 24 volt DC and has a power consumption of 125 W. Installation As installation is generally carried out at heights, the installation personnel must follow the relevant safety regulations during installation. -
Page 6: Mounting On Traverse With Slotted Borehole
LAMBRECHT meteo | PROFESSIONAL-IX 3.0 5.2 Mounting on traverse with slotted borehole The traverse (ID 32.14567.010 000) has a slotted hole with Ø 30 mm at each end. Remove the lower nut from the sensor. Put a sensor with assembled cable sidewise into the bore. -
Page 7: Earthing
5.7 Connection of sensor electronics PROFESSIONAL-IX 3.0 sensors will be connected to a data measuring system via the open cable end (please see chapter 10). The connecting cable is suitably installed along the mast between the data evaluation device (indicating aem.eco... -
Page 8: Safety Regulations
LAMBRECHT meteo | PROFESSIONAL-IX 3.0 instrument or data acquisition system) and the sensor. The cable must be secured using appropriate cable ties (length depends on the mast diameter). The cable routing should be arranged in accordance with the installation site. -
Page 9: Accessories
Mast adapter 32.14567.010000 Traverse Disposal LAMBRECHT meteo GmbH is listed and registered at the Stiftung Elektro-Altgeräte Register ear under: WEEE-Reg.-Nr. DE 45445814 In the category of monitoring and control instruments, device type: “Monitoring and control instruments for exclusively commercial use”. -
Page 10: Dimensional Drawings And Connections
LAMBRECHT meteo | PROFESSIONAL-IX 3.0 10 Dimensional drawings and connections page – aem.eco... -
Page 11: Connection Diagrams
LAMBRECHT meteo | PROFESSIONAL-IX 3.0 Connection diagrams aem.eco page –... -
Page 12: Technical Data
< 1° < 0.1 m/s Starting value 0.4 m/s 0.4 m/s Copyright © 2024 LAMBRECHT meteo GmbH. All rights reserved. Information in this document subject to change without notice. 1460x_3.0_b-de.indd 21.24 Photo copyright: © ville - Adobe stock LAMBRECHT meteo GmbH +49-(0)551-4958-0 Friedländer Weg 65-67...
Need help?
Do you have a question about the PROFESSIONAL-IX 3.0 and is the answer not in the manual?
Questions and answers