Connecting To A Non-Wps Wireless Router - Kodak ESP Networking Setup Manual

Hide thumbs Also See for ESP:

Setting Up a Wireless (Wi-Fi) Connection

Before you connect, you need:

• a wireless router.

• to determine whether your wireless router supports Wi-Fi Protected Setup (WPS).

NOTE: If you have specific questions about your router, see your router manufacturer's documentation.

Connecting to a non-WPS wireless router

Record your network information in the spaces below, using the correct uppercase and lowercase letters.

Network Name (SSID): ____________________________________________________

Security String (case-sensitive): ____________________________________________

NOTE: If you already set up your printer, you need to press Home, then press

Settings , then WiFi Setup Wizard . Press OK after each selection.

1. Press

to select Wireless , then press OK .

2. Press

to select your network, then press OK.

If you don't see your network in the list, or if you want to change your network, select Rescan for

Wireless Networks

If the name of your network is not listed, make sure your wireless router is turned on and within

range. If the name of your network is still not listed, go to www.kodak.com/go/inkjetnetworking.

3. If your network requires a password, use the LCD keyboard to enter your Security String. The

Security String is case-sensitive.

On the control panel (both types of keyboards), press

numbers, using the correct uppercase and lowercase letters. Press OK after each character. When

you are done, select DONE, then press OK.

, then press

www.kodak.com/go/aiosupport

to select Network

to select the letters and

Table of Contents