Table of Contents
Advertisement
If...
Picture is too light.
Picture is not clear.
Picture is too dark.
Camera does not
recognize SD card.
Camera freezes up
when a card is
inserted or
removed.
Memory card full.
www.kodak.com/go/support
Try one or more of the following
■
Move so there is at least 2 ft (0.6 m) between the camera and the
subject.
■
Decrease Exposure Compensation (see
■
Clean the lens
(see page
■
Make sure your camera is not in Close-up mode.
■
Move so there is at least 2 ft (0.6 m) between the camera and the
subject.
■
Place the camera on a flat, steady surface or use a tripod.
■
Turn on the flash (see
■
Move so there is no more than 7.9 ft (2.4 m) between the camera and
the subject.
■
Use Fill flash
(see page
behind the subject.
■
Increase Exposure Compensation (see
■
Purchase a certified SD card.
■
Insert a card into the slot, then push to seat (see
■
Turn the camera off, then back on. Make sure the camera is turned off
before inserting or removing a card.
■
Insert a new card (see
■
Transfer pictures to the computer (see
■
Delete pictures/videos (see
page
38).
page
6).
6) or change your position so light is not
page
page
3).
page
page
12).
Troubleshooting
22).
22).
page
3).
27).
31
Advertisement
Table of Contents
