Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Silver Star SHOWPRO Aurora UV IP
Summary of Contents for Silver Star SHOWPRO Aurora UV IP
- Page 1 Aurora UV IP LEDPAR211 USER MANUAL LIPSE MID COLOR 180 SS5141...
-
Page 2: Technical Specifications
1 PRODUCT 1.1 TECHNICAL SPECIFICATIONS Type Aurora UV IP 365nm UV Power 110W Voltage Range AC100~240V,50/60Hz Beam Angle 46° Protection IP65 -20℃~45℃ Operation Temperature Dimensions 320x418x219mm Weight 6.5kg DIMENSIONS... -
Page 3: Safety Warning
1.2 Safety Warning Always read the user manual before operation. Please confirm that the power supply stated on the product is the same as the mains power supply in your area. IMPORTANT ⚫ This product must be installed by a qualified professional. ⚫... -
Page 4: Installation
2 INSTALLATION 2.1 MOUNTING This fixture can be mounted in any position. Always ensure that mounting surface can withstand 10 times the weight of the fixture. Always use a safety cable when mounting the fixture in any elevated position. • Always use a safety cable when installing this unit. •... -
Page 5: Data Network Requirements
2.3 Data network requirements The DMX console and the lamp body are connected in series. Because the STD.P MODE is four channels, the address code of the lamp increases by 4, for example (1, 5, 9, 13…) The DMX address code can be any value between 001 and 512. As shown on the right, the controller is connected to the lamp body in series, the DMX address for the first lamp is set to 1, the second unit is set to 5, and so on. - Page 6 3.2 Menu...
-
Page 7: Dmx Address Setting
3.3 Static • Enter the STATIC mode to create the programs. • Combine UV/STROBE to create a definite range of colours. Use the up and down buttons to adjust 0~255 value, set value of the STROBE, push the up and down buttons to adjust 0~25Hz value •... - Page 8 3.6 Personality Press UP or DOWN to select UNO, DOS, STD.P. Please refer to DMX channel table for the specific channel value. 3.7 Setting...
- Page 9 • SETTING: this menu allows the user to adjust key operation settings for this fixture. • Select UPLOAD to upload the custom programs from the current MASTER unit to the SLAVE units. • RESET: reset the fixture. Enter the password "up down up down" to confirm, and then perform the RESET of the lamp parameters.
-
Page 10: Using A Dmx512 Controller
4 USING A DMX512 CONTROLLER 4.1 Channel Assignment This product has the following DMX personalities: UNO, DOS, and STD.P STD.P VALUE FUNCTION 000 – 255 Ch.1 Ch.1 Ch.1 DIMMER 000 – 255 Ch.2 Ch.2 DIMMER FINE STROBE 000 – 009 No Function 010 –...
Need help?
Do you have a question about the SHOWPRO Aurora UV IP and is the answer not in the manual?
Questions and answers