Preparing To Spray - X-Stream CLEAN XCAASX icroBurst 2.0 Operation Manual

STEP 2
MICROBURST 2.0
OPERATION GUIDE

PREPARING TO SPRAY

1. Charge the battery fully before first use. In a separate container,
prepare the solution you want to spray according to the
manufacturer's instructions. Open the tank lid and carefully pour
the solution through the intake filter. Securely tighten the tank lid.
2. Attach the 110° fan nozzle by threading it onto the carbon fiber
wand.
3. Insert the battery into the battery holster located on the backside
of the sprayer, beneath the ComfortStraps back pad, and snap
the battery in place.
4. Turn the pump on by flipping the power switch on the side of the
unit.
5. Begin spraying by squeezing the trigger on the
spray handle.
PRIMING YOUR SPRAYER
NOTE: Although rare, when spraying for the first time or after storing the
sprayer for an extended amount of time, the sprayer may need help priming.
If the sprayer turns on and you can hear the pump running, but no liquid is
passing through the sprayer, you will need to manually prime the sprayer
according to the steps below:
1. With the sprayer off, remove the battery and make sure the battery
cover is shut.
2. Remove the tank lid and take the tank strainer out to reveal the inside
of your sprayer tank.
3. Locate the inlet filter at the bottom of the sprayer tank. Gently wiggle
the inlet filter until it comes apart from the pump connection. Set aside.
4. Using a garden hose or similar delivery method, rapidly run clean
water into the connection where the inlet filter was.
5. Reinstall the inlet filter with the mesh screen facing the bottom of the
tank, fill the sprayer with some water, and insert a charged battery. Test
the sprayer by activating the spray trigger.
© WESSOL, LLC 2024
15.