Table of Contents
Advertisement
3.4.4 Storage Configuration
3.4.4
3.4.4
3.4.4
3.4.4
Storage Configuration
Storage Configuration
Storage Configuration
Storage Configuration
Advanced
Storage Configuration
OnBoard SATA Controller
SATAII_1
SATAII_2
v02.54 (C) Copyright 1985-2005, American Megatrends, Inc.
OnBoard SATA Controller
Use this to enable or disable onboard SATA controller. The default value is
[Enabled].
Advanced
SATAII_1
Device
Vendor
Size
LBA Mode
Block Mode
PIO Mode
Async DMA
Ultra DMA
S.M.A.R.T.
Type
LBA/Large Mode
Block (Multi-Sector Transfer)
PIO Mode
DMA Mode
S . M . A . R . T .
32Bit Data Transfer
v02.54 (C) Copyright 1985-2005, American Megatrends, Inc.
TYPE
Use this item to configure the type of the IDE device that you specify.
Configuration options: [Not Installed], [Auto], [CD/DVD], and [ARMD].
[Not Installed]: Select [Not Installed] to disable the use of IDE device.
[Auto]: Select [Auto] to automatically detect the hard disk drive.
After selecting the hard disk information into BIOS, use a disk
utility, such as FDISK, to partition and format the new IDE hard
disk drives. This is necessary so that you can write or read
data from the hard disk. Make sure to set the partition of the
Primary IDE hard disk drives to active.
3 0
3 0
3 0
3 0
3 0
BIOS SETUP UTILITY
Enable/Disable onboard
SATA controller.
[Enabled]
[Hard Disk]
[Not Detected]
Select Screen
Select Screen
Select Item
Select Item
+-
+-
Change Option
Change Option
F1
F1
General Help
General Help
F9
F9
Load Defaults
Load Defaults
F10
F10
Save and Exit
Save and Exit
ESC
ESC
Exit
Exit
BIOS SETUP UTILITY
Select the type
of device connected
:Hard Disk
to the system.
:ST340014A
:40.0 GB
:Supported
:16Sectors
:4
:MultiWord DMA-2
:Ultra DMA-5
:Supported
[Auto]
Select Screen
[Auto]
Select Item
[Auto]
+-
Change Option
[Auto]
F1
General Help
[Auto]
[Disabled]
F9
Load Defaults
[Enabled]
F10
Save and Exit
ESC
Exit
Advertisement
Table of Contents
