ASROCK P45TS-R User Manual page 24

Hide thumbs Also See for P45TS-R:
Table of Contents

Advertisement

Primary IDE connector (Blue)
(39-pin IDE1, see p.11/12 No. 8)
connect the blue end
to the motherboard
80-conductor ATA 66/100/133 cable
Note: Please refer to the instruction of your IDE device vendor for the details.
Serial ATAII Connectors
(SATAII_1 (Port0):
see p.11/12, No. 11)
(SATAII_2 (Port1):
see p.11/12, No. 12)
(SATAII_3 (Port2):
see p.11/12, No. 13)
(SATAII_4 (Port3):
see p.11/12, No. 14)
(SATAII_5 (Port4):
see p.11/12, No. 16)
(SATAII_6 (Port5):
see p.11/12, No. 15)
SATAII_6 (Port5) connector can be used for internal storage device or
be connected to eSATAII connector to support eSATAII device. Please
read "eSATAII Interface Introduction" on page 30 for details about eSATAII
and eSATAII installation procedures.
eSATAII Connector
(eSATAII_TOP: see p.11, No. 39
or p.12, No. 38)
Serial ATA (SATA)
Data Cable
(Optional)
IDE1
PIN1
These six Serial ATAII (SATAII)
connectors support SATA data
cables for internal storage
devices. The current SATAII
interface allows up to 3.0 Gb/s
data transfer rate.
This eSATAII connector
supports SATA data cable for
external SATAII function. The
current eSATAII interface
eSATAII_TOP
allows up to 3.0 Gb/s data
transfer rate.
Either end of the SATA data cable
can be connected to the SATA /
SATAII hard disk or the SATAII
connector on this motherboard.
You can also use the SATA data
cable to connect SATAII_6 (Port5)
connector and eSATAII connector.
2 4
2 4
2 4
2 4
2 4
connect the black end
to the IDE devices

Advertisement

Table of Contents
loading

This manual is also suitable for:

P45ts_mP45ts

Table of Contents