Trane BAYPWRX310A Installation Manual
  1. Manuals
  2. Brands
  3. Trane Manuals
  4. Ventilation Hood
  5. BAYPWRX310A
  6. Installation manual
Trane BAYPWRX310A Installation Manual

Trane BAYPWRX310A Installation Manual

Vertical and horizontal power exhaust
Hide thumbs
Table of Contents

Advertisement

Quick Links

Installation Guide
Vertical and Horizontal Power
Exhaust
Medium Foundation Packaged Rooftops,
7.5 to 12.5 Tons
208/230V Single Phase, 460V Three Phase
M M o o d d e e l l N N u u m m b b e e r r s s : :
BAYPWRX310A (230V)
BAYPWRX311A (460V)
Only qualified personnel should install and service the equipment. The installation, starting up, and servicing of heating, ventilating, and air-conditioning
equipment can be hazardous and requires specific knowledge and training. Improperly installed, adjusted or altered equipment by an unqualified person
could result in death or serious injury. When working on the equipment, observe all precautions in the literature and on the tags, stickers, and labels that
are attached to the equipment.
October 2021
U U s s e e d d w w i i t t h h : :
EBC 090-150, GBC 090-150
EBC 090-150, GBC 090-150
S S A A F F E E T T Y Y W W A A R R N N I I N N G G
R R T T - - S S V V N N 0 0 4 4 6 6 A A - - E E N N

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the BAYPWRX310A and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Trane BAYPWRX310A

Summary of Contents for Trane BAYPWRX310A

  • Page 1 M M o o d d e e l l N N u u m m b b e e r r s s : : U U s s e e d d w w i i t t h h : : BAYPWRX310A (230V) EBC 090-150, GBC 090-150...
  • Page 2 A A L L W W A A Y Y S S r r e e f f e e r r t t o o a a p p p p r r o o p p r r i i a a t t e e S S a a f f e e t t y y D D a a t t a a impact to the environment. Trane advocates the...
  • Page 3 This document and the information in it are the property of Trane, and may not be used or reproduced F F a a i i l l u u r r e e t t o o f f o o l l l l o o w w i i n n s s t t r r u u c c t t i i o o n n s s b b e e l l o o w w c c o o u u l l d d r r e e s s u u l l t t i i n n in whole or in part without written permission.

  • Page 4: Table Of Contents

    Table of Contents General Information ......5 Parts List....... . . 5 Unit Inspection .

  • Page 5: General Information

    General Information Parts List Power exhaust is designed for downflow applications. An economizer must be installed and functional before Figure 1. Vertical package installing the power exhaust. Unit Inspection To protect against loss due to damage incurred in transit, perform inspection immediately upon receipt of the unit.

  • Page 6: Installation

    Installation Vertical Power Exhaust 4. Remove the 216-inch power whip from the parts bag. Route the bare wire end through the gland in 1. Open and lock the unit’s disconnect switch. the R/A opening, see Figure 5, p. 6. Fasten this wire 2.
  • Page 7 I I n n s s t t a a l l l l a a t t i i o o n n 6. Route wire through control box grommet and Figure 8. Economizer panel terminate wires to the RTU terminal block located in the RTU control box.
  • Page 8 I I n n s s t t a a l l l l a a t t i i o o n n Figure 10. Routing wires to economizer panel 9. Route the 2 loose wires though a grommet on the economizer panel.
  • Page 9 I I n n s s t t a a l l l l a a t t i i o o n n Figure 12. Three phase power exhaust wiring diagram 10. Fasten the power exhaust hood assembly over the 11.

  • Page 10: Horizontal Power Exhaust

    I I n n s s t t a a l l l l a a t t i i o o n n Horizontal Power Exhaust 4. Remove the 216-inch power whip from the parts bag. Route the bare wire end through the grommet 1.
  • Page 11 I I n n s s t t a a l l l l a a t t i i o o n n 5. Route this wire through the condensing section of Figure 19. High voltage terminal block the RTU and fasten along the existing wire run to ensure it does not interfere with unit operation.
  • Page 12 I I n n s s t t a a l l l l a a t t i i o o n n 8. The opposite end of the power whip has a 4-pin a. For BAYECON310A, install a red jumper female plug.
  • Page 13 I I n n s s t t a a l l l l a a t t i i o o n n Figure 23. Single phase power exhaust wiring diagram Figure 24. Three phase power exhaust wiring diagram RT-SVN046A-EN...
  • Page 14 I I n n s s t t a a l l l l a a t t i i o o n n 11. Fasten the power exhaust hood assembly over the 12. Close the unit disconnect switch. opening cut in the return air ductwork. Reattach the horizontal economizer hood, and install the filter access door.
  • Page 15 N N o o t t e e s s RT-SVN046A-EN...
  • Page 16 For more information, please visit trane. com or americanstandardair.com. Trane and American Standard have a policy of continuous product and product data improvement and reserve the right to change design and specifications without notice. We are committed to using environmentally conscious print practices.

This manual is also suitable for:

Baypwrx311a

Table of Contents