Storage Configuration - ASROCK P43 PRO USB3 User Manual

3.4.4 Storage Configuration

3.4.4 3.4.4 Storage Configuration Storage Configuration Storage Configuration
3.4.4 3.4.4 Storage Configuration
BIOS SETUP UTILITY
Advanced
Storage Configuration
SATAII Configuration
Configure SATAII as
[Hard Disk]
SATAII 1
[Not Detected]
SATAII 2
[Not Detected]
SATAII 3
[Not Detected]
SATAII 4
SATAII 5 [Not Detected]
[Not Detected]
eSATAII 1
AHCI CD/DVD Boot Time out
v02.54 (C) Copyright 1985-2003, American Megatrends, Inc.
SATAII Configuration
Please select [Compatible] when you install legacy OS. If native OS
(Windows XP / Vista
® TM
the option "Configure SATAII as", you are allowed to set the selection to
[IDE] or [AHCI]. The default value is [IDE].
If you select [AHCI] mode, the options "Hot Plug" and "SATA Link Power
Management" will appear. Configuration options: [Enabled] and [Disabled].
The default value is [Enabled].
AHCI (Advanced Host Controller Interface) supports NCQ and other
new features that will improve SATA disk performance but IDE
mode does not have these advantages.
BIOS SETUP UTILITY
Advanced
Primary IDE Master
Device :Hard Disk
:ST340014A
Vendor
Size :40.0 GB
LBA Mode :Supported
Block Mode :16Sectors
PIO Mode :4
Async DMA :MultiWord DMA-2
Ultra DMA :Ultra DMA-5
S.M.A.R.T. :Supported
Type [Auto]
[Auto]
LBA/Large Mode
[Auto]
Block (Multi-Sector Transfer)
[Auto]
PIO Mode
[Auto]
DMA Mode
[Disabled]
S . M . A . R . T .
[Enabled]
32Bit Data Transfer
v02.54 (C) Copyright 1985-2005, American Megatrends, Inc.
Options
Disabled
[Enhanced]
Compatible
[IDE]
Enhanced
Select Screen Select Screen
[35]
Select Item Select Item
+- +- Change Option Change Option
F1 F1 General Help General Help
F9 F9 Load Defaults Load Defaults
F10 F10 Save and Exit Save and Exit
ESC ESC Exit Exit
/ 7) is installed, please select [Enhanced]. Then in
Select the type
of device connected
to the system.
Select Screen
Select Item
+- Change Option
F1 General Help
F9 Load Defaults
F10 Save and Exit
ESC Exit
4 5 4 5 4 5
4 5 4 5