Advertisement
Quick Links
Smart Controller
Installation Guide
Installation requires no
special tools
Model V3
adhguardianusa.com
1-424-272-6998
Install the beam Smart Controller
1
• Verify that your garage door opener is connected to power.
• Plug the Smart Controller into the
on your garage door opener. Make sure the Smart Controller is fully inserted and
flush with the garage door opener.
TIP: After plugging-in the Smart Controller verify that LED on the smart controller is blinking
(orange). If the LED
Controller for 10 seconds, the garage door opener will beep 3 times.
1
Get the most from
your beam Smart
Controller!
• Share access with
others
Invite friends and family
within the app.
• Explore integrations
beam plays well with
others, from IFTTT to
Amazon Alexa.
• Register your Smart
Controller
Enter:
adhguardianusa.com/
content/product-
registration
does not blink orange, press the Reset Button
B
beam smart port, look for the beam logo
B
2
Thank you for
purchasing the beam
Smart Controller!
Read and follow all
installation instructions.
TIP: Setup with the beam
Home app and homeowner's
smartphone.
Have home network ID and
password with you during
set-up.
A
Smart Controller
on the Smart
C
C
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Guardian Beam V3
Summary of Contents for Guardian Beam V3
- Page 1 Get the most from Thank you for your beam Smart purchasing the beam Controller! Smart Controller! • Share access with Read and follow all others installation instructions. Invite friends and family TIP: Setup with the beam within the app. Home app and homeowner’s •...
- Page 2 To reduce the risk of injury to persons: • Use this Smart Control only with Residential Sectional Garage doors. • Do not enable this device on a one-piece or swinging garage door. Guardian Access & Door Hardware 1761 International Pkwy, Ste 113 Richardson, TX 75081 www.adhguardianusa.com...
Need help?
Do you have a question about the Beam V3 and is the answer not in the manual?
Questions and answers