Maintenance; Specifications - Aiwa CT-X418 Operating Instructions Manual

MAINTENANCE
SPECIFICATIONS
Cleaningthe front panei
When
the
front panel
is soiled, wipe the surface
of the panel with a dry and soft cloth.
Cieaningthe tape head
Use a cleaning
cassette to clean the playback
head and capstans approximately once a month.
If the playback head is dirty, the high tones may
not be reproduced properly.
Cieaningthe connector
The connector on the reverse side of the front
panel needs to be cleaned occasionally. Wipe
the surface of the connector with a cotton swab
slightly moistened with alcohol.
RADiOSECTION
(FM)
Frequency Range:
87.5 MHz–1 08 MHz
(100-kHz steps)
87.5 MHz–1 08 MHz
(50-kHz steps)
Ussble Sensitivity 12.7dBf
50 dB Quieting Stmsitivity
17.2 dBf
IF Rejection:
80 dB
Frequency Response: 30 Hz-15,000 Hz
S/N Ratio:
83 dB
Stereo Separation:
35 dB at 1 kHz
Alternate Channef Selectivity
70 dB
Capture Ratio 3 dB
(AM)
Frequency Range: 530 kHz–1 ,710 kHz
(10-kHz steps)
522 kHz–1 ,620 kHz
(9-kHz steps)
Usable Sensitivity 30 PV (30 dB)
TAPESECTION
Wow/Fluttec O.I"A (WRMS)
Tape Speed
4.8 cm/sec. (1 7/8ips)
SIN Ratio: 50 dB
Frequency Responee 40 Hz-14,000 Hz
Stereo Separation: 40 dB
FFIREW Time: 190 sec. (C-80)
AUDIOSECTION
Max. Power Output 40 W x 4 channels
CDiN input
Input sensitivity (load impedance)
CD IN: 500 mV (1O kf2)
GENERAL
Power-Supply Voltage
14.4 V (1 i to 16 V allowable),
DC, negative ground
Load Impedance: 4 Q
Tone Control:
Bass* 10dBat 100Hz
Trebla * 10 dB at 10 kHz
Preamp Output Voltage (load Impedance):
2.2 V (10 kQ)
Installation eize
182 (W)
X
53 (H)
X
155 (D) mm
(7 l/. (W)
x
2 '/8 (H)
X
6 1/6(D) inchee)
Accessory supplied: Carrying case (1)
* Specification and external appearance are subject to
change without notice due to product improvement.
ENGLISH 12