Asrock I/O Tm; Connectors - ASROCK K7VM3 User Manual

2.8 Connectors

Connectors are NOT jumpers. DO NOT place jumper caps over
these connectors.
Connector
FDD connector
(33-pin FLOPPY1)
(see p.7 item 19)
Note: Match the red marking on the floppy ribbon cable with Pin1.
Primary IDE connector (Blue)
(39-pin IDE1, see p.7 item 10)
connect the blue end
to the motherboard
Note: To optimize compatibility and performance, please connect your hard disk
drive to the primary IDE connector (IDE1, blue) and CD-ROM to the
secondary IDE connector (IDE2, black).
USB 2.0 header
(9-pin USB45)
(see p.7 item 20)
Infrared module connector
(5-pin IR1)
(see p.7 item 21)
Internal audio connectors
(4-pin CD1, 4-pin AUX1)
(CD1: see p.7 item 29)
(AUX1: see p.7 item 30)
1 6
Figure
Secondary IDE connector (Black)
(39-pin IDE2, see p.7 item 9)
80-Pin ATA 100/133 cable
CD1
AUX1
Description
connect the black end
to the IDE devices
ASRock I/O TM provides 4
default USB 2.0 ports on the
rear panel. If those 4 USB 2.0
ports on the rear panel are not
sufficient, this USB 2.0 header
is available for 2 additional
USB 2.0 ports.
This connector supports an
optional wireless transmitting
and receiving infrared module.
These connectors allow you
to receive stereo audio input
from sound sources such as
a CD-ROM, DVD-ROM, TV
tuner card, or MPEG card.