Advertisement
Quick Links
MK3 RAIL SQUARE ULTRA REPEAT STOP
SET UP INSTRUCTIONS
CALIBRATION
SCREW WITH T-NUT
FENCE JOINER BAR
HEX KEY 3
MM
HEX KEY 2.5
MM
HEX KEY 2
MM
FLAGSTOP WITH THUMSCREW
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
TAKE THE MK3 REPEAT STOP AND LOCATE THE LONG SLOTS
WITH THE FLAT SIDE OF THE EXTRUSION FACING DOWN.
TAKE THE SUPPLIED THUMBSCREWS WITH
THE PLASTIC WASHERS.
FOR MORE INFORMATION PLEASE VISIT
STAINLESS STEEL REPEAT
STOP THUMBSCREW WITH
2X PLASTIC WASHERS
CONNECTOR BLOCK
LOCATE THE RS (REPEAT STOP) HOLES
SCREW DOWN THE REPEAT STOP BUT DON'T FULLY TIGHTEN.
CONTACT@BENCHDOGS.CO.UK
REPEAT STOP
LINE UP THE REPEAT STOP SLOTS TO THE RS
HOLES ON THE RAIL SQUARE
SLIDE ON YOUR FLAGSTOP AND TIGHTEN DOWN THE
THUMBSCEW AT YOUR CHOSEN LENGTH (WE HAVE SET IT AT 30MM)
WWW.BENCHDOGS.CO.UK
MK3 RAIL SQUARE
1
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Bench Dog Tools MK3 RAIL SQUARE ULTRA REPEAT STOP
Summary of Contents for Bench Dog Tools MK3 RAIL SQUARE ULTRA REPEAT STOP
- Page 1 MK3 RAIL SQUARE ULTRA REPEAT STOP SET UP INSTRUCTIONS STAINLESS STEEL REPEAT REPEAT STOP STOP THUMBSCREW WITH 2X PLASTIC WASHERS CONNECTOR BLOCK CALIBRATION SCREW WITH T-NUT FENCE JOINER BAR HEX KEY 3 HEX KEY 2.5 HEX KEY 2 FLAGSTOP WITH THUMSCREW...
- Page 2 MK3 RAIL SQUARE ULTRA REPEAT STOP SET UP INSTRUCTIONS SLIDE THE REPEAT STOP TOWARDS THE TRACK AND CHECK THAT USING A RULER OR TAPE MEASURE, SLIDE IT UNDER TIGHTEN UP THE THUMBSCREWS ONCE THE THE MEASUREMENT IS READING THE SAME MEASUREMENT ON YOUR TRACK AND BUTT IT UP TO THE FLAGSTOP.
Need help?
Do you have a question about the MK3 RAIL SQUARE ULTRA REPEAT STOP and is the answer not in the manual?
Questions and answers