Table of Contents
Advertisement
2. If you use AC'97 audio panel, please install it to the front panel audio
header as below:
A. Connect Mic_IN (MIC) to MIC2_L.
B. Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to OUT2_L.
C. Connect Ground (GND) to Ground (GND).
D. MIC_RET and OUT_RET are for HD audio panel only. You don't
need to connect them for AC'97 audio panel.
E. Enter BIOS Setup Utility. Enter Advanced Settings, and then select
Chipset Configuration. Set the Front Panel Control option from
[Auto] to [Enabled].
F. Enter Windows system. Click the icon on the lower right hand
taskbar to enter Realtek HD Audio Manager. Click "Audio I/O", select
"Connector Settings"
detection", and save the change by clicking "OK".
System Panel Header
(9-pin PANEL1)
(see p.10 No. 16)
Chassis Speaker Header
(4-pin SPEAKER 1)
(see p.10 No. 15)
Chassis Fan Connector
(3-pin CHA_FAN1)
(see p.10 No. 19)
CPU Fan Connector
(4-pin CPU_FAN1)
(see p.10 No. 6)
ATX Power Connector
(20-pin ATXPWR1)
(see p.10 No. 3)
ATX 12V Connector
(4-pin ATX12V1)
(see p.10 No. 2)
, choose "Disable front panel jack
This header accommodates
PLED+
PLED-
PWRBTN#
several system front panel
GND
functions.
1
DUMMY
RESET#
GND
HDLED-
HDLED+
Please connect the chassis
1
SPEAKER
speaker to this header.
DUMMY
DUMMY
+5V
Please connect a chassis fan
GND
+12V
cable to this connector and
CHA_FAN_SPEED
match the black wire to the
ground pin.
Please connect a CPU fan cable
+12V
CPU_FAN_SPEED
to this connector and match
GND
FAN_SPEED_CONTROL
the black wire to the ground pin.
Please connect an ATX power
supply to this connector.
Please connect an ATX 12V
power supply to this connector.
2 1
2 1
2 1
2 1
2 1
Advertisement
Table of Contents
