Honeywell HDH-125, HDH-132, HDH-142 Troubleshooting Manual

Honeywell HDH-125, HDH-132, HDH-142 Troubleshooting Manual

Also See for HDH-125:

Advertisement

Honeywell HDH-125, HDH-132, HDH-142 Troubleshooting Manual

Troubleshooting

Before calling for service, review the chart below

PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION

Unit fails to operate

  1. Power Off
Turn power On
  1. Power cord unplugged
Plug in power cord
  1. Water tank not fitted correctly
Re-position water tank
  1. Water tank is Full
    (P2 appears on the display)
Empty water tank
  1. Defrosting
    (P1 appears on the display)
After defrosting, the unit will start dehumidifying again

Performance decreased

  1. Blocked air filter
Wash and dry nylon air filter
  1. Room windows and doors open
Close room windows and doors
  1. Obstacles in air outlet or air inlet
Remove obstacles

Unit noisy

  1. Unstable setting of unit
Reposition unit on a flat, level surface
  1. Blocked air filter
Wash and dry nylon air filter

Water on floor

  1. Hose to connector or hose connection may be loose
Tighten hose connections
  1. Intended to use the tank to collect water, but the back drain plug is removed
Install back drain plug

E1 or E2 appears in the display

  1. Humidity sensor error or Temperature sensor error
Unplug the unit and plug it back in, if error repeats, call for service

Documents / Resources

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download Honeywell HDH-125, HDH-132, HDH-142 Troubleshooting Manual

Advertisement

Need Assistance?

Do you have a question about the HDH-125 that isn't answered in the manual? Leave your question here.

Error while submitting your question. Please, reload page and try again.

Thank you! Your question has been received!

Table of Contents