Getting Started - VTech Stack and Slide Penguin Pals Instruction Manual

GETTING STARTED

Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Locate the battery cover on the back of
the unit, use a screwdriver to loosen the
screw and then open the battery cover
3. Remove the old battery by pulling up on
each end of the battery.
4. Install 1 new AAA battery following the diagram inside the
battery box. (For best performance, alkaline batteries or fully
charged Ni-MH rechargeable batteries are recommended.)
5. Replace the battery cover and tighten the screw to secure.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
IMPORTANT: BATTERY INFORMATION
• Insert batteries with the correct polarity (+ and -).
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries.
• Only batteries of the same or equivalent type as recommended
are to be used.
• Do not short-circuit the supply terminals.
• Remove batteries during long periods of non-use.
• Remove exhausted batteries from the toy.
• Dispose of batteries safely. Do not dispose of batteries in fire.
5
5
5