ASROCK A785GMH 128M - V1.0 User Manual page 44

CPU Frequency Multiplier
This option appears only when you adopt Phenom CPU. However, for
safety and system stability, it is not recommended to adjust the value of this
item.
NB Frequency Multiplier
This option appears only when you adopt Phenom CPU. However, for
safety and system stability, it is not recommended to adjust the value of this
item.
HT Bus Speed
This feature allows you selecting Hyper-Transport bus speed. Configura-
tion options: [Auto],[x1 200 MHz] to [x5 1000 MHz]. If you adopt Phenom
CPU, the configuration options are: [Auto], [x1 200 MHz] to [x13 2600 MHz].
The configuration options depend on the CPU you adopt.
HT Bus Width
This feature allows you selecting Hyper-Transport bus width. Configura-
tion options: [Auto], [8 Bit] and [16 Bit].
Memory Configuration
Memory Clock
This item can be set by the code using [Auto]. You can set one of the
standard values as listed: [200 MHz (DDR2 400)], [266 MHz (DDR2 533)],
[333 MHz (DDR2 667)] and [400 MHz (DDR2 800)]. If you adopt Phenom
CPU, there is one more option: [533MHz (DDR2 1066)].
DRAM Voltage
Use this to select DRAM voltage. Configuration options: [Auto], [1.80V] to
[2.72V]. The default value is [Auto].
Memory Timing
BIOS SETUP UTILITY
OC Tweaker
Memory Timing
[Unganged]
Memory Controller Mode
[Disabled]
Power Down Enable
[Auto]
Bank Interleaving
[XOR of Address bit]
Channel Interleaving
Timing : 4-4-4-12
CAS Latency (CL) [Auto]
TRCD [Auto]
TRP [Auto]
TRAS [Auto]
Timing : 2-2-2-4-16
TRTP [Auto]
[Auto]
TRRD
[Auto]
TWTR
[Auto]
TWR
[Auto]
TRC
v02.54 (C) Copyright 1985-2003, American Megatrends, Inc.
Select Screen Select Screen
Select Item Select Item
+- +- Change Option Change Option
F1 F1 General Help General Help
F9 F9 Load Defaults Load Defaults
F10 F10 Save and Exit Save and Exit
ESC ESC Exit Exit
4 4 4 4 4 4 4 4 4 4