Table of Contents
Advertisement
2.8 Onboard Headers and Connectors
2.8 Onboard Headers and Connectors
2.8 Onboard Headers and Connectors
2.8 Onboard Headers and Connectors
2.8 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper caps
over the headers and connectors will cause permanent damage of the
motherboard!
•
Floppy Connector
(33-pin FLOPPY1)
Pin1
(see p.13 No. 25)
Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the
connector.
Primary IDE connector (Blue)
(39-pin IDE1, see p.13 No. 9)
connect the blue end
to the motherboard
80-conductor ATA 66/100/133 cable
Note: Please refer to the instruction of your IDE device vendor for the details.
Serial ATAII Connectors
(SATAII_1 (PORT 0):
see p.13, No. 17)
(SATAII_2 (PORT 1):
see p.13, No. 16)
(SATAII_3 (PORT 2):
see p.13, No. 15)
(SATAII_4 (PORT 3):
see p.13, No. 14)
SATAII_1 SATAII_2
(SATAII_5 (PORT 4):
(PORT 0) (PORT 1)
see p.13, No. 11)
(SATAII_6 (PORT 5):
see p.13, No. 10)
Serial ATA (SATA)
Data Cable
(Optional)
FLOPPY1
IDE1
PIN1
These six Serial ATAII (SATAII)
connectors support SATAII
or SATA hard disk for internal
storage devices. The current
SATAII_5 SATAII_6
SATAII interface allows up to
(PORT 4) (PORT 5)
3.0 Gb/s data transfer rate.
SATAII_3 SATAII_4
(PORT 2) (PORT 3)
Either end of the SATA data cable
can be connected to the SATA /
SATAII hard disk or the SATAII
connector on this motherboard.
2 7
2 7
2 7
2 7
2 7
the red-striped side to Pin1
connect the black end
to the IDE devices
Advertisement
Table of Contents
