ASROCK 890GX EXTREME3 User Manual page 53

Memory Timing
BIOS SETUP UTILITY
OC Tweaker
Memory Timing
[Unganged]
Memory Controller Mode
[Disabled]
Power Down Enable
[Auto]
Bank Interleaving
[HASH 2]
Channel Interleaving
CAS Latency (CL) [Auto]
9
TRCD [Auto]
12
TRP [Auto]
12
[Auto]
TRAS
30
TRTP [Auto]
5
TRRD [Auto]
4
TWTR [Auto]
5
TWR [Auto]
10
[Auto]
TRC
33
TRWTWB [Auto]
8
TRWTTO [Auto]
7
TWRRD 2 [Auto]
v02.54 (C) Copyright 1985-2003, American Megatrends, Inc.
Memory Controller Mode
It allows you to adjust the memory controller mode. Configuration options:
[Unganged] and [Ganged]. The default value is [Unganged].
Power Down Enable
Use this item to enable or disable DDR power down mode.
Bank Interleaving
Interleaving allows memory accesses to be spread out over banks on the
same node, or accross nodes, decreasing access contention.
Channel Interleaving
It allows you to enable Channel Memory Interleaving. Configuration options:
[Disabled], [Address bits 6], [Address bits 12], [HASH 1] and [HASH 2]. The
default value is [HASH 2].
CAS Latency (CL)
Use this item to adjust the means of memory accessing. Configuration
options: [Auto], [4CLK] to [12CLK]. The default value is [Auto].
TRCD
Use this to adjust TRCD values. Configuration options: [Auto], [5CLK] to
[12CLK]. The default value is [Auto].
TRP
Use this to adjust TRP values. Configuration options: [Auto], [5CLK] to
[12CLK]. The default value is [Auto].
TRAS
Use this to adjust TRAS values. Configuration options: [Auto], [15CLK] to
[30CLK]. The default value is [Auto].
TRTP
Use this to adjust TRTP values. Configuration options: [Auto], [4CLK] to
[7CLK]. The default value is [Auto].
Select Screen Select Screen
Select Item Select Item
+- +- Change Option Change Option
F1 F1 General Help General Help
F9 F9 Load Defaults Load Defaults
F10 F10 Save and Exit Save and Exit
ESC ESC Exit Exit
5 3 5 3 5 3 5 3 5 3