Advertisement
Quick Links
OIL SEPARATOR
Installation, Operation, & Maintenance Guide
913-222-1500
HELP@STRIEMCO.COM
CUSTOMER SERVICE HOURS: 8 AM - 5 PM CST
4/28/22
OT-500
STRIEMCO.COM
Installation, Operation, & Maintenance Guide
OVERVIEW
Striem Oil Tanker™ model OT-500 is a 562 gallon polyethylene oil separator intended for below-grade
installation. It is designed to separate oil and solids from wastewater.
OIL TANKERS - LARGE EXTERIOR UNITS
OPERATION
Oily wastewater enters through the inlet connection. As the wastewater moves through the unit, solids and
**For buried applications only
immiscible lighter-than-water contaminants are separated based on Stokes' Law. Immiscible, lighter-than-water
Sheet Descriptions
droplets rise out of the wastewater stream, while sediment and sludge settle to the bottom.
Sheet #1 - Series overview, Warranty information, Operations & Maintenance
Sheet #2 - Installation Instructions
Sheet #3 - TeleGlide Riser Installation Instructions
LIFETIME WARRANTY
Leak/Seal Testing
Our products are designed to last the lifetime of the plumbing system in which they are installed. If they don't,
DO NOT AIR TEST UNIT OR RISER SYSTEM! Doing so may result in property damage, personal injury or death.
we will repair or replace them at no charge. Product damage due to normal wear and tear may be repaired or
To perform a leak/seal test on the base unit, cap/plug all plumbing connections, remove a cover, and fill the unit with water just above the
highest connection. Inspect unit and connections for leaks. Check water level at specific time intervals per local code. Note: This unit has been subjected
to a 24 hour water test prior to shipment from the factory.
replaced at a reasonable charge. See website for full details.
Lifetime Warranty
Our products are designed to last the lifetime of the plumbing system in which they are installed. If they don't, we will repair or replace them at no charge. Product
damage due to normal wear and tear may be repaired or replaced at a reasonable charge.
See website for full details.
Call Striem with questions or suggestions @ 1-913-222-1500 Customer Service Hours: 8 AM-5 PM CST
OIL TANKER
OIL SEPARATOR
LIFETIME
LIFETIME
GUARANTEED
GUARANTEED
OT-500
OIL SEPARATOR
(Model OT-500)
OT-500
PROPRIETARY AND CONFIDENTIAL
THE INFORMATION CONTAINED IN THIS DRAWING IS THE SOLE PROPERTY OF STRIEM, LLC.
SERIES
ANY REPRODUCTION IN PART OR AS A WHOLE WITHOUT THE WRITTEN PERMISSION OF STRIEM, LLC. IS
TM
PROHIBITED.
562 GALLON
KANSAS CITY
FLO
DESC
O
SHEE
DWG
Built in
Advertisement
Related Manuals for Striem OT-500
Summary of Contents for Striem OT-500
- Page 1 OIL SEPARATOR Installation, Operation, & Maintenance Guide OVERVIEW Striem Oil Tanker™ model OT-500 is a 562 gallon polyethylene oil separator intended for below-grade installation. It is designed to separate oil and solids from wastewater. OIL TANKERS - LARGE EXTERIOR UNITS...
- Page 2 Slower than usual drainage may indicate a blockage and a need to maintain the Oil Tanker. Effluent flow fouled with free oil may indicate the OT-500 has exceeded the maximum oil capacity. In the Ensure the drain lines and diffusers are cleared of all debris in the presence of slow drainage.
- Page 3 (by others) UNIT INSTALLATION Lower and center the unit into hole using Striem lifting lug kit (included). Do not use chains or accessways to move the unit. The water table must not exceed the tank height prior to the addition of risers.
Need help?
Do you have a question about the OT-500 and is the answer not in the manual?
Questions and answers