Subscribe to Our Youtube Channel
Related Manuals for Avantco Equipment 177PBD3
Summary of Contents for Avantco Equipment 177PBD3
- Page 1 User Manual 01/2024 177PBD3 Powdered Beverage Dispenser Base Models: #177PBD3 Note: Please read the manual thoroughly prior to equipment setup, operation, and maintenance. www.AvantcoEquipment.com...
-
Page 2: Table Of Contents
User Manual Powdered Beverage Dispenser Index Safety ..............................3 Specifications ............................3 Parts Identification ..........................4 Installation ..............................6 Operation Instructions ........................6 Programming Instructions ........................7 Cleaning ..............................9 E478819 E478819 CONFORMS TO UL STD. 197 CONFORMS TO NSF/ANSI STD. 4 www.AvantcoEquipment.com... -
Page 3: Safety
Install the machine in a dry area away from water and water splashes. • DO NOT operate if your hands or feet are wet. • Please keep 15cm (6") minimum air space all around the dispenser. Specifications Model No. 177PBD3 Voltage AC120V 50Hz Heater Power 1600W Water Reservoir Hot Water Tank 1.8L... -
Page 4: Parts Identification
User Manual Powdered Beverage Dispenser Parts Identification (Front) Button Board (B) (DRINK A (DRINK B (DRINK C Sticker Sticker Sticker WATER Goes Here) Goes Here) Goes Here) Water inlet LED display Button board Drink outlets Powder canisters Mixing system Mode switch Waste water tray Mode Switch (G) Mode... - Page 5 User Manual Powdered Beverage Dispenser Parts Identification (Back) Exhaust fan Wire connect for water pump Pipe connect for water pump Fuse set Power switch Hot water drain pipe Water reservoir Powder dispensing motor Mixing motor Heating tank www.AvantcoEquipment.com...
-
Page 6: Installation
User Manual Powdered Beverage Dispenser Installation NOTE: Please use filtered and softened water. If using ground or tap water, please soften it first. Carefully unpack the machine and check for damage and missing parts. 2. Place the unit on a stable, flat surface in a dry area near power supply and water supply. Do not connect water line or power cord at this time. -
Page 7: Programming Instructions
User Manual Powdered Beverage Dispenser 5. Set the water temperature. (See "Menu Functions" below for more information on setting the water temperature.) - After setting the water temperature the unit will display "HEA" while it heats up to temp. - Once the unit reaches desired temp, it will display "rEA". 6. - Page 8 User Manual Powdered Beverage Dispenser Data Settings To activate all drink data setting functions, press the "Mode" button located on the inside panel of the door. 2. After Pressing "Mode," the LED display will show "SET." You can now navigate through the drink data settings.
-
Page 9: Cleaning
User Manual Powdered Beverage Dispenser Cleaning • DO NOT use harsh chemicals or abrasive materials. • DO NOT submerge or saturate with water, unit is not waterproof. • Cleaning should be done at the end of every workday. • Only those persons trained and qualified in equipment repair should attempt to clean the inside of this dispenser.
Need help?
Do you have a question about the 177PBD3 and is the answer not in the manual?
Questions and answers