Table of Contents
Advertisement
Problem
... if the oven suddenly stop functio-
ning.
... if the oven suddenly stops functio-
ning and the electronic timer flashes
:
?
{
{{
... if
is displayed?
Å
... if –
– is displayed?
... if the symbols on the control panel
illuminate, but the Main oven is not
heating up?
... if the symbols on the control panel
illuminate, but the Mini oven is not
heating up?
... if electronically controlled func-
tions fail?
... if the hydroclean system control
lamp fails to illuminate after the func-
tion has been activated?
... if enamelled slide-in parts have
dull, light blotches?
... if after prolonged use, the oven
window panes are soiled from the
inside.
Trouble-shooting Guide
Possible cause
The electronic timer is set to an auto-
matic timing cycle.
The power supply was briefly inter-
rupted.
The power supply was briefly inter-
rupted.
The oven is locked (childproof lock).
The Main oven was locked to pre-
vent unauthorised use (safety off fun-
ction).
The Mini oven was locked to prevent
unauthorised use (safety off func-
tion).
Energy pulses (e.g. lightning flash).
Temperature inside oven cavity is still
too high.
Defective control lamp.
Normal occurrence due to dripping
meat juices.
This kind of soiling is normal.
Remedy
Set electronic timer to operation
without automatic timer:
1. Reset ON time
g
2. Press the
button.
g
Reset the time of day.
Re-activate the electronic timer and
oven control.
Rotate the function selector 3x from
the
position to
. Oven light –
a
{
goes out.
Using the function selector, switch
5 x from the hot air
v
conventional
and back again.
e
must be displayed.
~ ~ ~
Using the function selector, switch
5 x from the conventional
to grill
and back again.
0
must be displayed.
~ ~ ~
Reset the relevant functions.
Prior
to
using
the
system, the oven must be allowed to
cool completely.
Replacement only by an authorised
expert.
Not possible.
Remove the oven door and lay
front side down on a soft, clean
base.
Grip the door glass near the hinges,
pull up and remove.
Doors with 3 panels:
Disengage inner door glass at the
corner pieces and lift it up using, for
example, a pair of frying tongs made
of plastic or wood.
Installing the cleaned glass:
Insert the inner door glass and lock
into position.
Attach the door glass and lock into
position by pressing the glass near
the hinges.
to
.
{:{{
–
Å
position to
position
e
hydroclean
29
Hide quick links:
Advertisement
Table of Contents
