STOREMORESTORE SMS-10-V80-TSHD Assembly Manual

3
I I
I I
Lab Workbench Assembly Guide
SMS-10-V80-TSHD
StoreMoreStore.com | 855-786-7667 | sales@storemorestore.com
ASSEMBLE NYLON GlIDE TO SQUARE INSERT
li
FOR EACH LEGO DRliVE SQUARE BUSHING WlilH
GLliDE liNTO BOTTOM OF EACH LEG USliNG A MALLET
OR HAMMERO
2 ASSEMBLE FRONl AND BACK RAliL USING SlUD
PLATES AND LOCK NUTS PROVIDEDO THE 2 X 2 X 1
CHANNEL KS FOR lHE FRONT OF THE UNIT AND THE
X 8 CHANNEL KS FOR THE REAR JHEN ATTACH THE
li
X HEX HEAD BOLT AND FLAl WASHER
li/4" - 20 3/4"
THE BOTTOM MOST HOLE THE BACK RAliL (BEFORE
10 KN
lliGHTENliNG NUTS MAKE SURE THAT THE FRONT RAIL AND
BACK RAliL ARE FLUSH TO THE TOP OF THE LEG ASSEMBlIES
AND PUSHED INWARD APPROXIMATELY
ALLOW THE WORKSURFACE TO BE MOUNTED PROPERLY)
NOTE: HOLES IN RAlilS SHOUlD BE FACING UP
3 PLACE WORKSURFACE BOTTOM UP ON A PROJECTED
SURFACE PROJECT LAMINATE FROM SCRATCHES)
!TO
PLACE ASSEMBLED FRAME ON BACKSIDE OF TOP,
LOCATE FLUSH WlilH BACK EDGE OF LEGO {SEAM OF EDGING
BACKlo USE DRliLL BIT AND PRE-DRliLL HOLES
10 #28
DEEP AND SCREW X
li/2" #12 3/4"
SECURE FRAME TO TOP"
NOTE: OVERHANG OF THE TOP SHOULD EE
IN THE FRONT AND THE SIDES !FlUSH WliTH BACK)
WHEN ASSEMELliNG A QUANTITY OF BENCHES
AN ELECTRIC SCREW GUN IS RECOMMENDEDO
4 SEl BENCH UPRIGHT AND ADJUST NYLON
GUDES TO LEVEl
TO
li/8"
SCREWS KN TO
2 li/2"