Washing The Dishes - NEFF S4930N1 Instructions For Use Manual

en
Programme data
The programme data (duration, energy
and water consumption) can be found in
the summary of instructions and refers to
standard conditions. Greater deviations
may be caused by:
different quantities of utensils
inlet temperature of the water
water pressure
ambient temperature
mains voltage tolerances
and appliance-specific tolerances
(e.g. temperature, water flow rate, etc.)
The water consumption values refer
to water hardness value 2.
16

Washing the dishes

Switching on the appliance
Turn on the tap fully.
Check once again that the spray arms
can rotate freely.
Select a programme with the
programme selector
a clockwise direction only).
Press the main switch
The indicator light
The programme starts.
Programme sequence indicator
While the dishes are being washed, the
programme selector rotates in a clockwise
direction and indicates how far the
programme has progressed.
End of programme
The programme has ended when the
pump noise is no longer audible and the
programme selector has reached its initial
position (12 o'clock position).
Switching the dishwasher OFF
Several minutes after the programme has
ended:
Set the main switch
The indicator light
Turn the water tap off. (Does not apply
when Aqua–Stop unit has been fitted)
It is not necessary to reset the
programme selector.
Remove dishes, etc. when they have
cooled down.
(rotate in
1
.
5
illuminates.
7
to OFF.
5
extinguishes.
7