Page 1
The battery connection cable is used for connecting the expansion battery and the power station. To connect, insert the cable directly with the Anker logo in the top center. You will hear a click when the cable is locked. To disconnect, push the knob and turn it 12.5 degrees counterclockwise before pulling it out.
Page 2
2. Recharge the power station via AC input or DC input. The plug varies by region. When the expansion battery is connected successfully, you will hear a beep and will appear on the power station's screen. The expansion battery will be charged after the power station is fully charged. Powering Your Devices 1.
Page 3
If the expansion battery is stored at a low capacity for a long time, lithium batteries will self-consume power which may lead to a quick discharge. This often leads to poor conductivity and a reduced battery lifespan that causes the battery not to work. When storing your expansion battery, make sure that you: 1.
Need help?
Do you have a question about the SOLIX BP1000 and is the answer not in the manual?
Questions and answers