Maintenance; Cleaning; Inspection - Omron PROFIBUS DP GATEWAY Operation Manual

Maintenance

4-3

Maintenance

4-3-1

Cleaning

! C a u t i o n
4-3-2

Inspection

Inspection Equipment
Inspection Procedure
60
This section describes the routine cleaning and inspection recommended as
regular maintenance.
Clean the PRT1-SCU11 regularly as described below in order to keep it in an
optimum operating condition.
• Regularly wipe the Unit with a dry, soft cloth.
• If a spot cannot be removed with a dry cloth, dampen the cloth with a neu-
tral cleaner, wring out the cloth and wipe the Unit.
Never use volatile solvents such as paint thinner, benzine or chemical wipes.
These substances could damage the surface of the Unit.
Be sure to inspect the system periodically to keep it in optimum operating con-
dition. In general, inspect the system once or twice a year, but more fre-
quently if the system is used in high temperature or high humidity
environments or dirty/dusty conditions.
Prepare the following equipment before inspecting the system.
Required Equipment
Phillips type screwdriver, multimeter, alcohol, and a clean cloth.
Optional Test Equipment
Depending on system conditions, a synchroscope, oscilloscope, thermometer
or hygrometer (to measure humidity) might be needed.
Check the items in the following table and correct any that are below stan-
dard.
Item
Environmental Ambient temperature
conditions
Ambient humidity
Dust/dirt accumulation
Installation Are the units installed securely?
Are the communications connec-
tors fully inserted?
Are the external wiring screws
tight?
Are the connecting cables undam-
aged?
Section 4-3
Standard Equipment
0° C to 55° C Thermometer
10% to 90% Hygrometer
None ---
No looseness ---
No looseness ---
No looseness ---
No damage ---