Usable Support Tools - Omron PC CONNECTION - 04-1997 Operation Manual

Usable Support Tools

1-3 Usable Support Tools
1-4
When using the PT in a multi-vendor system, one of the following support tools
must be used.
NT-ZA3AT-EV2 (Ver.2.3j)
The programmable controllers (PC) that can be connected to the PT are deter-
mined by the "Direct Macn Type" data set in the screen data memory board. Ac-
cordingly, screen data complying with the programmable controller to be con-
nected must be transferred to the PT in advance.
The "Direct Macn Type" is set with the support tool. The applicable programmable
controllers (PCs) depending on the "Direct Macn Type" setting are as follows.
Direct Macn Type
NONE
OMRON
MEL-A
MEL-FX
Applicable Programmable Controller (PLC)
For connections without direct connection (e.g. RS-232C)
For connection to an OMRON C series or CVM1/CV se-
ries PC, or for a memory link connection.
For connection to a Mitsubishi Electric MELSEC A series
PC
For connection to a Mitsubishi Electric FX series PC
Chapter 1-3