Page 1
Screwless Clamp Terminal Socket P2RF@@S • Screwless clamping greatly contributes to reducing wiring time. • No over or under tightening of cable connection so better con- tact reliability is achieved. • Double wiring possible on all the terminals, and easy bridge and branch connections.
Page 2
P2RF-05-S 38.2 max. 36.5 max. 32.6 27.6 22.6 Standard model (5.3) 28.5 61.3 TYP 18.0 max. 32.6 Option (with ejector and Option (with ejector and label attached) label attached) P2RF-08-S 38.2 max. 36.5 max. 32.6 27.6 (3.4) 22.6 Standard model (5.3)
60.6 TYP 55.7 56.9 28.6 28.6 (5.30) (5.30) ■ Accessories (Option) Socket Bridge for P2RF-S Clip and Release Lever for P2RF-S Insulating coating P2CM-S 16.8 TYP 40.1 TYP Diameter conductor 1.2 mm 6 TYP List of models (32.0) 36 TYP...
, AWG24 to AWG16 Applicable Wire Type Note: 1. If the outer diameter D of the wire is less than 2.2 mm and the exposed conductor length is less than 8mm potentially Solid wires, standard wires, flexible wires, or wires with ferules can bad connection might occur in case wire is pushed to far in- be used.
Page 5
■ Wiring Wire connection hole Use wires of the applicable sizes specified above. The length of the exposed conductor should be 8 to 9 mm. Release hole Insert Screwdriver 8.5 ±0.5 mm Fig. 3 Section A-A of Fig. 2 Fig. 1 Exposed Conductor Length Use the following wiring procedure.
ALL DIMENSIONS SHOWN ARE IN MILLIMETERS. To convert millimeters into inches, multiply by 0.03937. To convert grams into ounces, multiply by 0.03527. In the interest of product improvement, specifications are subject to change without notice. Cat. No. J132-E2-02-X...