My Pet Command MPCGPS3 Quick Start Manual

My Pet Command MPCGPS3 GPS Dog Fence Collar
Please check this Video on Setup tips: -
https://www.youtube.com/watch?v=h9YUbGR2AvI&t=50s
Please always allow about 25FT space from house Boundary walls to the start of any fence lines. Also
allow 5-25Ft Variance for Positioning due to GPS Satellite Positioning
Test Procedure is: -
1. Connect APP to collar when you are with your collar (Make sure Bluetooth and location
services are switched ON on your smartphone for connection to happen). Please note
Bluetooth connection between collar and APP is short distance only like 10-15FT, so when
connected make sure collar and APP are close to each other
2. If You have more than 1 Collar, you connect to one collar one at a time via Bluetooth and
the APP. Please note APP is Only used to setup/download and test your fence so once all
setup your collar works on its own without any connection to the APP and fence is stored
in the collar memory not the APP.
3. Setup and save fence (Click Finish), which will download fence to collar
4. Also activate Fence Switch to ON and we recommend Alarm level 3 (Refer to Manual on
levels). Collar LED will blink Either red/Green when fence is activated.
Green Flash= Strong Satellite signals (Collar is outside)
Red Flash=Weak/No Satellite signals (For example collar is inside house)
5. Go Outside with the collar in your hand and connected to your APP and wait few minutes for
the collar to blink Green so it has got Satellite signals. With a connected collar to the APP
and Green Blink, on your app you will see Paw Icon which shows the collar positioning and
you can reference that to its real position. Always allow some Variance as explained above