Havis TC-111 Installation Instructions

IMAGE 1
A
USB TYPE C CABLE (NOT
INCLUDED) CAN BE USED FOR
CHARGING WHEN TABLET IS NOT
DETAIL A
DOCKED WITH THE DS-TAB-100.
SCALE 2 : 3
! DO NOT PULL HARD ON
CONNECTOR CABLE DURING
ASSEMBLY OR POSSIBLE
DISCONNECT MAY OCCUR
HARDWARE KIT CONTENTS
ITEM NO. DESCRIPTION
THREAD-FORMING SCREW, WASHER HEAD,
1 M2.5 STS+ THREAD, 6MM LONG, T8 DRIVE, STEEL,
ZINC-NICKEL PLATED, BLACK
2 T-8 PIN-IN TORX BIT
IMAGE 2
APPLE PENCIL DOCKING PORT
FOR WIRELESS CHARGING
DRIVE
QTY. FINISH
STYLE/ SIZE
WARNING: ALL HAVIS INC. PRODUCTS ARE DESIGNED WITH SAFETY OF USE AND INSTALLATION IN MIND. HOWEVER,
IT IS THE SOLE RESPONSIBILITY OF THE OWNER/OPERATOR OF A VEHICLE USING HAVIS INC. MOUNTING AND
DOCKING EQUIPMENT, TO INSURE THAT THE EQUIPMENT IS INSTALLED SO THAT IT WILL NOT INTERFERE WITH VEHICLE
ZINC-NICKEL
OPERATION, INTERFERE WITH SAFETY DEVICES, OBSTRUCT VIEW OF DRIVING CONDITIONS, OR IN ANY WAY
12 PLATED, T8
DEGRADE OCCUPANT SAFETY. IMPROPER INSTALLATION CAN CAUSE SERIOUS INJURY IN THE EVENT OF AN
BLACK ACCIDENT. INSTALLATION SHOULD ONLY BE PERFORMED BY QUALIFIED PROFESSIONALS. COMPUTERS AND
MOTION DEVICES MUST BE MOVED TO AND STOWED/SECURED IN THEIR SAFE DRIVING POSITIONS BEFORE
OPERATING VEHICLE.
1 N/A 1/4" HEX
INSTALLATION INSTRUCTIONS:
IMAGE 3
1. Note the cable routing detailed in Image 1, Detail A.
2. Insert the connector from the Protective Case into
the Apple iPad, maintaining the orientation shown
in Detail A.
DO NOT PULL HARD ON CONNECTOR CABLE
DURING ASSEMBLY OR POSSIBLE DISCONNECT
MAY OCCUR AND RESULT IN FAILURE TO
CHARGE, OR PASS DATA TO/FROM THE DEVICE.
3. Place the iPad into the Rear Protective Case and
ensure that the cable routing matches that shown
in Detail A. Be careful not to pinch the cable.
IMAGE 4
4. Place Front Protective Case onto the rear, noting
that the Havis logo should be positioned on the
bottom side (connector side) of the iPad. Ensure
that the cable is not pinched when placing the two
halves together.
5. Your Protective Case includes four (4) snap fits
located in the areas circled in Image 2. Apply light
pressure until all the snaps are interlocked.
6. Holding the two pieces together, carefully turn the
Protective Case over.
7. Fasten all eight (8) of the M2.5 x 6mm screws (Item
#1) with the supplied T8 torx bit (Item #2) into the
locations shown in Image 3. Torque to 4 in-lbs +/-
10%. Do not over-tighten screws.
NOTE: Hardware kit includes extra screws in the
event of loss or damage.
NOTE: Protective case will allow for storage and
charging of compatible Apple Pencil in location
noted in Image 4.
DRAWING NO.
TC-111_INST_11-22
PRODUCT DESCRIPTION
ASSY, TABLET CASE, APPLE IPAD AIR
4TH & 5TH GENS
WEIGHT: (LBS) WEIGHT: (LBS) WEIGHT: (LBS)
2.225
REV. DATE
11-22
1-800-524-9900
WWW.HAVIS.COM
F-730-019 REV B