EVGA CPU Closed Loop Water Cooling Kit Installation Manual page 3

2)
Next, screw the stando into the backplate of the
motherboard. LGA 12XX / 115X socket motherboards,
please use part B to screw the stando into the
baseplate. For LGA 17XX, use part J. Intel LGA 20XX users
should use part A to screw the stando into the
threaded mounting holes in the corners of the
socket's retention clamps. Use parts C and D for
AMD platforms.
3)
Make sure the correct retention ring is installed on the
pump / cooler, and then install the unit onto the stando s.
We have included both an Intel and AMD retention
ring in the package, with the Intel ring preinstalled. To
change the retention ring, turn the ring counter-clock-
wise and remove the ring from the pump.
4
4)
1
Secure the retention ring using screw nuts. Please
2
follow the tightening order; this prevents the CPU and
3
socket from being damaged.
5)
Install the radiator and fan. Connect the fan and pump to
the motherboard's 3 or 4-pin fan headers; please check
your motherboard's manual for where to locate these fan
headers, as connecting to an incorrect header may cause
irreparable damage to the components.
6)
Install the USB cable to enable PWM-tuning via software.
Connect the cable from the CPU pump to the USB 2.0 front
panel header on the motherboard.
The CPU Water Block software can be downloaded at the
link below:
http://www.evga.com/support/download/