Table of Contents
Advertisement
Newentor®
Weather Station
(Save the Instructions for Future Peference)
I . ' ` . . I l l
a :::'i'ce@newentorcom
ill 5:Caer%°h?kNewentor
Newentor weather station is a functional product and with the correct
settings will accurately show your local weather. If there are any questions
about the use or functions, contact us through any of the above methods
to get support.
Advertisement
Table of Contents
Need help?
Do you have a question about the Q7 and is the answer not in the manual?
Questions and answers
No display on remote sensor new batteries inserted
The Newentor Q7 remote sensor may have no display after inserting new batteries due to incorrect battery orientation, low-quality or depleted batteries, or failure to perform a full power cycle on the main Q7 unit. To resolve this, ensure batteries are inserted with correct polarity, use fresh batteries, and try removing power from the main Q7 unit and restarting it to re-establish connection.
This answer is automatically generated
Cannot get the outside temp to register batteries are good on same channel as before was working before then tried to stop the damn alarm and I pushed the wrong button how do you stop the alarm very unfriendly controls
To stop the alarm on the Newentor Q7, press any button on the main unit except the “ :tt/ZZ ” button. If no button is pressed, the alarm will automatically stop after 2 minutes and sound again after 24 hours.
To fix the outside temperature registration issue, reset the weather station:
1. Use a sharp, thin object to press the "RESET" button on the back of the main unit.
2. Remove and reinsert the batteries.
3. If using a power cord, unplug the adapter and plug it back in.
4. If additional batteries are inserted, briefly remove and reinsert them as well.
After restoring power, the display will show all symbols briefly, light up, and emit a beep, indicating a reset.
This answer is automatically generated
the temp inside always stays the same why doesn't it changed
The temperature inside the Newentor Q7 may remain constant if the indoor temperature changes less than 1.8°F (1°C) in 1 minute, as the main unit updates the temperature reading every 30 seconds in such cases. If the temperature change exceeds 1.8°F (1°C) in 1 minute, the update frequency increases to every 10 seconds. If the temperature is not updating, it could be due to a lack of significant temperature change within the update intervals.
This answer is automatically generated
oh is there way to keep screen ON all the time while plugged in?
i hit mode lightly OR for2 seconds and it wont go to eastern time or let me set correct time or date what am i missing ? mode doesnt seem to let me get off AM time and go to PM? thx
How do I change back to Fahrenheit? I don’t know how it went to centigrade
To change the Newentor Q7 from Celsius to Fahrenheit, press the UP or DOWN button while in the settings menu where the temperature unit is displayed.
This answer is automatically generated