U-Line H-1078 Quick Start Manual

π
H-1078
LIGHT DUTY
GLUE GUN
CAUTION! Keep out of reach of children.
WARNING! Never touch the nozzle of the gun
or hot melted glue as operating temperatures
can reach 400ºF and can cause severe burns.
• Do not use within 10' of any flammable materials.
• Not for use outdoors or in areas that may be wet or
damp.
• Keep all work areas clean and well-lit.
• Never use this gun with materials other than
recommended glue sticks.
1. Plug in gun to a 110 volt outlet.
2. Insert glue stick into back of gun.
3. Pull trigger several times until glue is set firmly into
the inlet tube.
4. Allow five minutes of warm-up time for the gun and
glue stick.
5. Apply appropriate amount of glue by squeezing
trigger.
6. Bond surfaces by pressing together within 15
seconds of applying hot glue. For best results,
ensure surfaces are clean of any oil and dirt.
PAGE 1 OF 3
1-800-295-5510
uline.com
SAFETY
OPERATION
• Always wear protective safety equipment such as
gloves, glasses, long sleeve shirts and pants when
using hot melt glue guns.
• When inserting glue sticks into a hot glue gun,
avoid using too much force as this can cause hot
glue to be unexpectedly discharged from nozzle or
flow back from inlet tube.
• Do not store in direct sunlight.
• Not for use with extension cords.
• Hot melt glue is not intended to replace structural
fasteners or in temperatures reaching over 130ºF.
7. Always use the provided glue gun stand in between
uses when gun is plugged in.
CAUTION! Never lay the glue gun on its side
while gun is still hot.
8. After use, always unplug gun and use provided glue
gun stand until gun has cooled before storing.
9. Never pull glue sticks out of the glue gun.
Para Español, vea página 2.
Pour le français, consulter la page 3.
0424 IH-1078