Introduction; Required Tools - Curtis Computer Automotive PC Enclosure VoomPC-2 Installation Manual

http://www.cartft.com, Cool Embedded PCs

1.0 Introduction

Thank you for purchasing the VoomPC-2 mini-ITX vehicle enclosure!
The VoomPC-2 was designed to work with a wide variety of main boards such as the VIA
mini-ITX boards as well as low power Pentium-M OR Core 2 Duo. Please note that
powering full power P4 or AMD systems is not recommended due to excessive heat
dissipation.

2.0 Required tools

+
Battery
GND
Ignition
Amplifier
Enable
In order to install the VoomPC-2 in your vehicle you will need the following:
-Phillips screwdriver and Wire cutter / stripper
-Few feet of wire (AWG 12-16), preferably color coded, used for power input.
VoomPC-2 Installation Guide
Reverse and
+
forward protect on i
-
SW
J2
Sw tch Log i ic 6-30V ATX PSU
8b t MCU i
M1-ATX
PC
power
MotherBoard
ON OFF switch /
J6
J8 Optional On/OFF switch
J4
LED
Page 3
ATX