Advertisement
Table of Contents
Advertisement
Table of Contents
Related Manuals for Sharkoon SKILLER SGK50 S2
Summary of Contents for Sharkoon SKILLER SGK50 S2
- Page 1 SKILLER Manual...
-
Page 2: Specifications
Cable and Connectors Connector USB Type-C „ Textile-Braided Cable ü „ Coiled Cable ü „ 150 cm Cable Length „ Gold-Plated USB Plug ü „ Package Contents SKILLER SGK50 S2, Keycap Puller Tool, Switch Puller Tool, USB Cable (150 cm) „... - Page 3 VIA/QMK If VIA configuration is not possible through the website at https://usevia.app/, please then use the alternative website at https://via.evove.top/.
-
Page 4: Macro Keys
Macro Keys Pause Pos1 Ende Bild Bild Entf Untbr ´ ` – ° " § & ß ? T ab Ü Pos1 Bild € Ö Ä < > Ende Bild µ Enter Strg Alt Gr Strg Einfg Entf Macro Start Recording Stop Recording Macro Key 1 Macro Key 2... -
Page 5: Lighting Effects
Lighting Effects Pause Pos1 Ende Bild Bild Entf Untbr ´ ` – ° " § & ß ? T ab Ü Pos1 Bild € Ö Ä < > Ende Bild µ Enter Strg Alt Gr Strg Einfg Entf Brightness + Brightness –... -
Page 6: Additional Functions
Additional Functions Pause Pos1 Ende Bild Bild Entf Untbr ´ ` – ° " § & ß ? T ab Ü Pos1 Bild € Ö Ä < > Ende Bild µ Enter Strg Alt Gr Strg Einfg Entf Play/Pause Previous Track Next Track Mute Volume –... - Page 7 Remove Keycaps Before removing a switch, first remove the keycap. To do this, place the arms of the keycap puller tool either to the left and right or to the top and bottom of the keycap, and then pull the keycap upwards with careful but constant pressure. Whenever possible, avoid pulling the keycaps from the switch directly with your fingers, as this may damage the switch.
- Page 8 Remove Switches Once you have removed the keycap from the switch, position the switch puller tool correctly on the tabs of the switch. These are positioned to the front and the back of the switch. Before pulling out the switch, make sure that both tabs are securely pressed with the switch puller tool and that the switch can be removed from the socket without resistance.
- Page 9 Install Switches To install the switches, position the switch so that one tab is at the front and the other tab is at the back. Each pin on the underside of the switch should be pointing exactly to its relevant contact in the keyboard socket. Make sure that the switch is led vertically into the socket opening (at a 90-degree angle to the socket).
- Page 10 All named products and descriptions are trademarks and/or registered trade- marks of the respective manufacturers and are accepted as protected. As a continuing policy of product improvement at Sharkoon, the design and specifications are subject to change without prior notice. National product specifications may vary.
- Page 11 Follow us on social media! Facebook Instagram YouTube TikTok Sharkoon Technologies GmbH Grüninger Weg 48 35415 Pohlheim Germany © Sharkoon Technologies 2024...
Need help?
Do you have a question about the SKILLER SGK50 S2 and is the answer not in the manual?
Questions and answers