Download
Share
Print this page
Stealth 97109-1139 Installation Manual
  1. Manuals
  2. Brands
  3. Stealth Manuals
  4. Automobile Accessories
  5. 97109-1139
  6. Installation manual

Stealth 97109-1139 Installation Manual

For 2007 - 2018 wrangler jk & jku
Hide thumbs

Advertisement

Quick Links

Download this manual
Installation Manual for 2007 - 2018 Wrangler JK & JKU
#97109-1139
TO REDUCE RISK OF SERIOUS INJURY OR PROPERTY DAMAGE: READ ALL
SAFETY MESSAGES AND UNDERSTAND ALL INSTRUCTIONS AND
PROCEDURE NOTICES BEFORE ATTEMPTING TO INSTALL OR USE THIS
PRODUCT.
RISK OF EYE INJURY! SAFETY GLASSES MUST BE WORN AT ALL TIMES
WHILE INSTALLING OR MAINTAINING THIS PRODUCT. DO NOT USE IF
DAMAGED.
CHECK STATE AND LOCAL HIGHWAY SAFETY LAWS REGARDING USE OF
AUXILLARY LIGHTING.
THESE ARE INTENDED FOR OFF ROAD USE ONLY.
WHEN ROUTING ELECTRICAL WIRES, ALWAYS AVOID PINCHING WIRES.
ALWAYS AVOID HOT OR MOVING COMPONENTS. ALWAYS SECURE WIRES
WITH CABLE TIES.
HOT SURFACE! DO NOT TOUCH LIGHT HOUSING WHILE IN OPERATION.

Advertisement

loading
Need help?

Need help?

Do you have a question about the 97109-1139 and is the answer not in the manual?

Questions and answers

Related Manuals for Stealth 97109-1139

Summary of Contents for Stealth 97109-1139

  • Page 1 Installation Manual for 2007 - 2018 Wrangler JK & JKU #97109-1139 TO REDUCE RISK OF SERIOUS INJURY OR PROPERTY DAMAGE: READ ALL SAFETY MESSAGES AND UNDERSTAND ALL INSTRUCTIONS AND PROCEDURE NOTICES BEFORE ATTEMPTING TO INSTALL OR USE THIS PRODUCT. RISK OF EYE INJURY! SAFETY GLASSES MUST BE WORN AT ALL TIMES WHILE INSTALLING OR MAINTAINING THIS PRODUCT.
  • Page 2 Before You Begin Installation: Congratulations on to shipping. If any part is missing or broken, your purchase of the Stealth LED Lightbar for your please call Customer Service at 800-745-6037 Jeep Wrangler. When unpacking, check to make as soon as possible.

  • Page 3: Parts List

    Quadratec Stealth Light Bar Parts & Tools: PARTS LIST: REQUIRED TOOLS: QTY 1 A) Light Bar Safety Glasses QTY 1 Phillips Head Screwdriver Small Flat B) Power Tap Harness C) Light Power Cord QTY 1 Head Screwdriver Forked Clip/Trim QTY 4...
  • Page 4 LED Lightbar Installation: for ’07-’10 JK FIG3 FIG4 Remove the two upper screws using a 7mm starting at the top. (FIG4) Using trim removal socket. (FIG 3) Using a trim clip removal tool tool pry the top lip and pull upward and out. gently remove the lower dash panel FIG5 FIG6...
  • Page 5 LED Lightbar Installation: for ’11-’18 JK FIG8 FIG9 Under the steering column remove the center panel Remove the two screws using a 7mm socket. by pulling it away from the dash releasing the clips. (FIG9) (FIG8) FIG10 FIG11 Using a trim clip removal tool gently re-move the On the window control switch slide the red locking window control switch or dash pocket if switches tab over, squeeze the black tab and disconnect the...
  • Page 6 LED Lightbar Installation: for ’11-’18 JK FIG13A FIG13 FIG14 On top of the dash lift up the rubber tray insert Lift the large dash top panel off and carefully and remove the screw using a 7mm socket. set it aside. (highlighted in FIG13A) (FIG13) Gently pull out on the climate control center to release the clips.
  • Page 7 LED Lightbar Installation: All Versions FIG17 FIG18 Open the glove box, squeeze in the sides to release Route the Power Tap Harness through the dash the stops (FIG 17) and tilt it down all the way, and out behind the glove box. (FIG18) remove it and set aside.
  • Page 8 LED Lightbar Installation: All Versions FIG21 FIG22 Remove the passenger side a-pillar trim clip using a Remove the lower a-pillar trim by pulling from the phillips head screwdriver. top. (FIG 22) There is one clip holding it to the a- pillar.
  • Page 9 LED Lightbar Installation: All Versions FIG25 FIG26 Connect power cord to light. Tilt the light bar into Fish the wire through the upper hole in the upper place, careful not to knock off the smaller end trim panel. (FIG 26) gaskets.
  • Page 10 / down at the windshield frame or pushing the light housing up / down where it connects to the housing. FIG31 Installation is now complete. Stealth light bar is compatible with all rear view mirror variations found in the Wrangler JK.
  • Page 11 LED Lightbar Use: All Versions FIG32 Switch Has 3 Positions: Position 1= White Light Center = Off Position 2 = Amber Light Observe location of the 3 Position Switch (switch position of switch may vary). See above for the various settings based on rocker switch position.
  • Page 12 Lifetime Limited Warranty Your Quadratec ® branded accessories are covered by alteration, modification, combination with other parts, the following Limited Warranty provided exclusively failure to maintain or improper repair or service, (b.) by Quadratec, Inc., 1028 Saunders Lane, West Chester normal wear &...