Advertisement
Quick Links
Installation Manual for '18 - 23 Wrangler JL / Gladiator JT Vehicles
W/O Active Cruise Control #97109.1129
TO REDUCE RISK OF SERIOUS INJURY OR PROPERTY DAMAGE: READ ALL
SAFETY MESSAGES AND UNDERSTAND ALL INSTRUCTIONS AND
PROCEDURE NOTICES BEFORE ATTEMPTING TO INSTALL OR USE THIS
PRODUCT.
RISK OF EYE INJURY! SAFETY GLASSES MUST BE WORN AT ALL TIMES
WHILE INSTALLING OR MAINTAINING THIS PRODUCT. DO NOT USE IF
DAMAGED.
CHECK STATE AND LOCAL HIGHWAY SAFETY LAWS REGARDING USE OF
AUXILLARY LIGHTING.
THESE ARE INTENDED FOR OFF ROAD USE ONLY.
WHEN ROUTING ELECTRICAL WIRES, ALWAYS AVOID PINCHING WIRES.
ALWAYS AVOID HOT OR MOVING COMPONENTS. ALWAYS SECURE WIRES
WITH CABLE TIES.
HOT SURFACE! DO NOT TOUCH LIGHT HOUSING WHILE IN OPERATION.
Advertisement
Related Manuals for Stealth 97109.1129
Summary of Contents for Stealth 97109.1129
- Page 1 Installation Manual for ’18 - 23 Wrangler JL / Gladiator JT Vehicles W/O Active Cruise Control #97109.1129 TO REDUCE RISK OF SERIOUS INJURY OR PROPERTY DAMAGE: READ ALL SAFETY MESSAGES AND UNDERSTAND ALL INSTRUCTIONS AND PROCEDURE NOTICES BEFORE ATTEMPTING TO INSTALL OR USE THIS PRODUCT.
- Page 2 Before You Begin Installation: Congratulations on to shipping. If any part is missing or broken, your purchase of the Stealth LED Lightbar for your please call Customer Service at 800-745-6037 Jeep Wrangler. When unpacking, check to make as soon as possible.
-
Page 3: Parts List
Stealth Light Bar Parts & Tools: PARTS LIST: REQUIRED TOOLS: A) Light Bar Safety Glasses QTY 1 B) Mounting Brackets Forked Clip/Trim Removal Tool QTY 2 C) Torx Screws Phillips Head Screwdriver Small QTY 4 D) Flat Washers Flat Head Screwdriver Ratchet... - Page 4 LED Lightbar Installation: FIG3 FIG4 Remove the center screw using a Phillips Gently pry out the window control panel head screwdriver and set aside.(FIG 3) from the top and work your way down. (FIG 4) FIG5 FIG6 Tilt panel away enough to access the 12v Connect new Power Tap Harness by socket connection.
- Page 5 LED Lightbar Installation: FIG8 FIG9 Push up on the glove box stop, tilt glovebox now replace all of the center dash parts in down, remove and set aside.(FIG8) Route the reverse order of removal. the power tap harness through the dash and Do not re-install the glove box yet.
- Page 6 LED Lightbar Installation: FIG13 FIG14 Unlatch and open the soft top or remove hard Remove the hardware using a T-40 Torx socket top front panels. Remove the felt padding on and loosely install the supplied brackets as top of the brackets hardware. (FIG 13) shown.
- Page 7 Position 1= White Light Center = Off Position 2 = Amber Light Note: Stealth Light Bar is NOT compatible with Stealth Light Bar is compatible with the standard rear view mirror as well as the auto- vehicles equipped with active cruise control dimming version (above right).
-
Page 8: Lifetime Limited Warranty
Lifetime Limited Warranty Your Quadratec ® branded accessories are covered by alteration, modification, combination with other parts, the following Limited Warranty provided exclusively failure to maintain or improper repair or service, (b.) by Quadratec, Inc., 1028 Saunders Lane, West Chester normal wear &...
Need help?
Do you have a question about the 97109.1129 and is the answer not in the manual?
Questions and answers