FJM security 7910 Quick Start Manual

7910
(K10 / K10P)
COMBI-CAM E
ELECTRONIC CABINET LOCK
CODE LEVELS -
The Combi-CamE has three potential code levels:
1. User code
2. Service code - (By default this is not active)
3. Master code
The user and master codes should be changed prior to installation. Write down the new codes and
keep in a safe place.
IMPORTANT!! You will be locked out and unable to open the lock if you forget or lose the codes.
There is no magic code or instructions to access the lock if you lose or forget the combinations.
USE MODES -
1. Individual Mode (Single User): This is the default mode. Once set, the same code opens the lock
each time.
2. Locker Mode: The user inputs their own code (gyms, theme park lockers, etc.) similar to the con-
cept of hotel safes. To set the lock up for Locker Mode, see the instructions on Page 7.
USER CODE -
Opening with user code - Factory default is <1-0-1-0>
To open the lock, enter your 4-digit user code. Initially, the default factory
user code is set to <1-0-1-0>. Rotate handle within 5 seconds in the opening
direction. You will get a confirming beep from the lock and the green LED
light will flash.
Changing the user code -
When individual usage is selected in program menu, press * button and enter
current 4-digit user code. Press * button again, enter new 4-digit user code.
Press * button again to approve new code. You will get a confirming beep and
the green LED light will flash. The new code is now set.
www.fjmsecurity.com | info@fjmsecurity.com
Toll free 800-654-1786
FJM Security Products — 7910 Combi-CamE Progamming the Lock Code
PROGRAMMING THE LOCK CODE
www.fjmsecurity.com
Page 1