EPIC SAFETY aero-k Installation Manual
Wi-fi/ethernet alarm system communicator
Hide thumbs
Also See for aero-k:
- Installation manual (57 pages) ,
- General installation manual (20 pages) ,
- General installation manual (23 pages)
Related Manuals for EPIC SAFETY aero-k
Summary of Contents for EPIC SAFETY aero-k
- Page 1 Wi-Fi/Ethernet Alarm System Communicator Napco Alarm Panels Installation Guide V1.6 Firmware V1.0...
-
Page 2: Table Of Contents
Contents Dial Capture (Tip/Ring) Monitoring & Keyswitch .................. 3 Wiring Diagram ..........................4 P801, XP400/600 ..........................4 P816/1632/1664/3200/9600, X255 ....................5 Programming Instructions ........................ 5 P801, XP400/600 ..........................5 P816/P1632/P1664 ........................... 6 iii. P3200/9600, X255 ..........................7... -
Page 3: Dial Capture (Tip/Ring) Monitoring & Keyswitch
1. Dial Capture (Tip/Ring) Monitoring & Keyswitch For Napco Alarm panels that support CID (Point ID) or SIA format, use Tip/Ring and keyswitch to monitor and control your system remotely. After installation, for proper partition mapping onto Aryo cloud and keyswitch arming, follow the instructions below: •... -
Page 4: Wiring Diagram
a. Wiring Diagram i. P801, XP400/600... -
Page 5: Programming Instructions
Programming Instructions To monitor Napco panels with dial capture, program your system as described below. Instructions in italics are for optional remote arming with keyswitch. PGMs on Aero-K can be connected to any zone programmed as keyswitch for remote arming functionality. -
Page 6: P816/P1632/P1664
[32] Set the receiver format to 6 for CID (Point ID). Turn each option on to enable alarm/restore reporting for all zones and keypad [34]-[36] alarms. [37]-[38] Turn option 4 on to enable alarm/restore reporting for fire alarms. [39] Turn each option on to enable open/close reporting for all users. [60]-[66] Set appropriate CID (Point ID) codes. - Page 7 iii. P3200/9600, X255 Section Description Direct Enter the installer code, and press ”Instant” button to scroll down until Address “ACTIVATE PROGRAM Y/N” is displayed. Press “Interior” to enter into the Dealer Programming programming mode. Then, press “Reset” to enter to Direct Access mode. Mode 0525 Enter C for CID (Point ID) or B for SIA format on the right digit.
Need help?
Do you have a question about the aero-k and is the answer not in the manual?
Questions and answers