HobbyBoss Me 262 B-1a/CS-92 Assembly Instructions Manual

PLEASE READ BEFORE OPERATION!
* Tools recommended as below: (Not included)
Adhesives; Paints; Side Cutters; Sharp Edged Pliers; Modeling Knife; Modeling
File; Nippers; Drill; Scissors; Sand Paper; Soft Cloth; Cyanoacrylate Glue.
* Make sure to read this instruction listed below before assembling.
* The kit contains the small parts, they can be dangerous if swallowed by mistake,
so keep them away from reach of children.
* Cut the all parts off carefully and remove the waste parts into the garbage can.
* More caution and care should be needed for cutting and handling the photo
etched parts.
* Make attention that some parts should be attached the decal when assembled.
* During assembling, please tear up and throw away the plastic bags, or may cause
the dangerous if wearing over head by children's mistake.
* When using the adhesives and paints, please do not use them in the closed room
or near the fire, also must be very careful to protect your eyes,face and clothes.
* Adult supervised when assembled by children under 14 years old.
m
H
cyanoacrylate glue
weight
强力胶 配重
The method to apply the decals
1 .Cut off the decal from the decal paper and put it into the warm water 40 °C for 10
seconds.
2. Take the decal from the water and put it on a piece of clean cloth.
3. Remove the decal slowly from the paper to the targeted location by a wet finger.
4. Use a piece of dry and soft cloth to press it gently on the decal until it getting dry
and no bubble existing.
80380
Ш
make hole cut / remove
钻孔 切除
装配前请仔细阅读：
* 推荐使用的模型工具(请自备)：
专用模型胶水，专用模型油漆，水口剪刀，长咀钳，刀片，
锉刀，镊子钳，钻，剪刀，软布，砂纸， 瞬间快干胶等。
* 用水口剪刀或刀片小心切下所有塑胶零件和蚀刻片零件，
不要遗失小零件。
* 切取蚀刻片时应特别注意防止利边划伤手指。
* 用模型锉刀小心锉平所有零件表面的注射浇口。
* 用适量的强力快干胶水粘合蚀刻片零件和金属轴，切忌过
量 ，否则可能导致可动零件被粘住。
* 注意某些零件表面需在装配时同步贴上水贴纸。
* 制作时应远离幼儿并将包装袋及时收妥，谨防小孩玩耍
而引起意外。
В
Q
option no cement
选择 不涂胶水
水贴纸的使用方法：
一. 把相关的印花从水贴纸上剪下，放入40°C左右的
温水中浸10秒。
二. 然后将印花放在干净的布上。
三. 拿上印花纸板，手指蘸水将印花移到适当的位置。
四. 用软干布轻压印花直至水干，气泡消失。
□
a
decal bend
贴纸
弯曲
В
repair
填补