HobbyBoss F8F-1 Bearcat Manual

ITUIIIIL8726]
F8F-1 Bearcat
F 8 F - 1 ^r^W b * I 1 F 8 F - 1
P L E A S E READ B E F O R E OPERATION!
* Tools recommended a s below: (Not included)
Adtiesives; Paints; Side Cutters; Sharp Edged Pliers; Modeling Knife; Modeling
File; Nippers; Drill; Scissors; Sand Paper; Soft Cloth; Cyanoacrylate Glue.
* Make sure to read this instruction listed below before assembling.
* The kit contains the small parts, they can be dangerous if swallowed by mistake,
so keep them away from reach of children.
* Cut the all parts off carefully and remove the waste parts into the garbage can.
* More caution and care should be needed for cutting and handling the photo
etched parts.
* Make attention that some parts should be attached the decal when assembled.
* During assembling, please tear up and throw away the plastic bags, or may cause
the dangerous if wearing over head by children's mistake.
* When using the adhesives and paints, please do not use them in the closed room
or near the fire, also must be very careful to protect your eyes.face and clothes.
* Adult supervised when assembled by children under 14 years old.
^^ti^
E M
a n tt^ i S S ^ * K 7 K ftSift Wft
Cyanoacrylate glue Weight Maltehole Cut/Remove Option N o cement Decal Bend Repair Install it first File/Sand
The method to apply the decals
1 .Cut off the decal from the decal paper and put it into the warm water 40 C for 10
seconds.
2. Take the decal from the water and put it on a piece of clean cloth.
3. Remove the decal slowly from the paper to the targeted location by a wet finger.
4. Use a piece of dry and soft cloth to press it gently on the decal until It getting dry
and no bubble existing.
* i 5 t 0 ^ 4 i 4 ' ' ^ ' ^ f i ^ ' f 5 , S v , iS't^fflo Please Keep instruction since it contains important information.
V
J
87267