Yamaha CrossCore RC Series Quick Start Manual

Dear New Yamaha CrossCore® RC or Wabash® RT e-Bike Owner,
Congratula�ons on your purchase of a new e-Bike during the Yamaha Bicycles EXTRAvaganza promo�on—and
thank you for comple�ng the owner's survey. Enclosed is your free extra batery that we promised as part of
this promo�on.
Your new batery will need to be assembled with the enclosed end cap and ac�vated before use. Please
follow these instruc�ons:
Do not drop the batery pack or subject it to impact. Doing so could cause the batery pack to become hot
or catch fire, resul�ng in serious injury or property damage.
1. You will need a 3 mm hex wrench ("Allen® key") to assemble the end cap correctly. Prepare a clean
workspace where you can unpack the batery. Be careful not to lose any parts. You should have these
components (see illustra�on below):
 Batery
 End cap (composite material)
 3 Cylindrical washers (collars)
TIP: If you are uncomfortable assembling the batery or don't have the proper wrench, feel free to visit your
Yamaha dealer or contact Yamaha Power Assist Bicycles Customer Rela�ons for assistance at 1-800-962-7926.
2. Posi�on the batery as shown with the orange-and-black Warning Label side facing down. Place the end cap on
the batery and make sure all of the holes in the end cap align with the threaded holes in the batery.
3. Put a cylindrical washer  on each hex-head screw
(  and  ) with the wider collar end up against the
screw head. Insert the screws in to the four holes in
the batery, paying close aten�on to the proper
loca�on of the shorter screw . Lightly finger �ghten
each one, being sure the end cap is properly aligned.
 3 Hex-head screws (long)
 1 Hex-head screw (shorter)
(Con�nued on other side)
WARNING LABEL
ON BOTTOM