Subscribe to Our Youtube Channel
Related Manuals for KINGrinder K6
Summary of Contents for KINGrinder K6
- Page 1 WHAT’S IN THE BOX Grinder KINGRINDER MANUAL HAND COFFEE GRINDER MANUAL Handle MODLE: K6 PC Lid with Black O-ring White O-ring & Circlip Brush There may be different versions; pictures are for reference only.
- Page 2 HOW TO OPERATE THE GRINDER? Gently rotate the adjustment nut clockwise until it stops at number 0. The number 0 is the correct zero position, do not over tighten it to past number Rotate the adjustment nut counterclockwise to the recommended grinding clicks (Please refer to the table below).
- Page 3 HOW TO CLEAN THE GRINDER? Disassemble: Rotate the adjustment nut anti-clockwise for three or four rotations. Holding the burr set while removing the circlip. Take out the components in order. The burr set (attached with the central shaft), the bearing cover, and the spring from the burr set. The top bearing cover and the top bearing from the above.
- Page 4 HOW TO USE IT BY ELECTRIC? You need to prepare: Electric screwdriver at a 15~25Nm torque. 6.35mm(1/4 inch) Hex Shank. Ensure that the bit holder is fully inserted Take out the handle and install into the center shaft, grasp the grinder the black O-ring to the PC lid.
Need help?
Do you have a question about the K6 and is the answer not in the manual?
Questions and answers