TE Connectivity 2217611-1 Instruction Sheet

PROPER USE GUIDELINES
Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use and low
volume applications. A wide selection of powered application equipment for extended-use, production operations is available.
Crimper Die
(Stationary)
Crimping Die
Assembly
2217611-1
The PRO-CRIMPER* III Hand Crimping Tool is a "Commercial" grade tool and is designed primarily
for field installation, repair, maintenance work, or prototyping in industrial, commercial, or institutional
applications. Product crimped with this tool will meet the crimp height requirement for hand tools in
the appropriate Application Specification (114-series), but may not comply with other feature
parameters of the specification. TE Connectivity offers a variety of tools to satisfy your performance
requirements. For additional information, contact the Tooling Assistance Center at 1-800-722-1111.
1. INTRODUCTION
(Figure 1)
This instruction sheet provides application and
maintenance procedures for SDE die set 2217611-1.
Figure 1 shows PRO-CRIMPER* III hand tool frame
(354940-1). See the last page of this document for
other available compatible tooling frames and related
instruction sheets to be used with this die set.
For information on connector part numbers and
connector assembly procedures, refer to the
appropriate instruction sheet packaged with the
connector.
NOTE
Dimensions in this instruction sheet are in metric units
[with U.S. customary units in brackets]. Figures and
illustrations are for reference only and are not drawn to
scale.
Read these instructions and all referenced materials
thoroughly before using the die and tool assembly.
© 2014 TE Connectivity Ltd. family of companies
All Rights Reserved
*Trademark
TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product, and/or company names may be trademarks of their respective owners.
SDE Hex Crimp
Die Set 2217611-1
PRO-CRIMPER* III
Frame Assembly
354940-1
Anvil Die
(Movable)
Figure 1
TOOLING ASSISTANCE CENTER 1-800-722-1111
PRODUCT INFORMATION 1-800-522-6752
2. DESCRIPTION
(Figure 2)
The die assembly features an anvil die and a crimper
die. When closed, the dies produce three crimping
chambers that crimp the ferrule of the connector.
Each die is held in the tool jaws with a single die-
retaining screw.
3. DIE INSTALLATION
(Figure 2)
1. Close the tool handles until the ratchet
releases; then allow the tool handles to open
FULLY.
2. Install anvil die in the moving jaw of the hand
tool. Align the die with the retaining screw
hole; then secure die with the button head
cap screw. Do NOT fully tighten.
3. Install crimper die in the stationary jaw of the
hand tool. Slowly close the tool handles,
allowing the die to align itself with the upper
die. When dies are properly aligned,
securely tighten both screws.
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.te.com.
Instruction Sheet
408-32122
Rev A
13 JAN 14
Die Retaining
Screws with
Tool Frame
1 of 4