emcom IP6030 Series Installation, Operation, And Programming Manual page 11

match the first. The length of the dialed string must match the length of the pattern. If the
phonebook contains "????" and "9???????????", then any number beginning with "9" must have
eleven additional digits, but any number beginning with a digit other than nine will initiate a call
after three more digits are dialed.
Sequence Number – Sequence numbers apply to phonebook entries with identical patterns and
different destinations. They specify the order in which succeeding calls are placed if the first call
does not go through. Sequence "1" would be the first attempt, Sequence "2" the second attempt,
etc.
Address Type – Address Type defines the method of communication. This should be left at SIP
Address.
User Name – This specifies the user ID field of the SIP-URI sent to the target destination. If the
Destination User Name is filled in with an ".", then the user ID field is composed of the input
condition (Pattern). This method can be used to pass a phone number dialed by the user to a
gateway, PBX, or other device that routes the call on the basis of the SIP-URI. If the Destination
User Name is anything but ".", it is copied to the user ID field literally. For direct calls from one
IP6030 to another, this field must contain "1". This field must always be specified, even for SIP
devices that ignore it. In the case of such devices, we recommend using ".".
Caller Address/Telephone Num – This is the IP address of the SIP device that is to receive the
call.
Destination Port – The Destination Port is a standard port number assigned to IP phones and
should be left at 5060.
Transport Protocol – The Transport Protocol should be left at Detect.
947214 Rev. F Page 11 of 15
IP6030 Family Rugged, Handset VoIP Phones
Installation, Operation and Programming V3
03 June 21