Third Reality Water Leak Sensor Manual page 8

Pairing with Hubitat
Website: http://find.hubitat.com/
Pairing Steps:
1. 1.Open the back cover of your Water Leak Sensor with a screw-
driver, insert two AAA batteries, if the blue light is not blinking
rapidly, please press the button for about 3s, when the read
light is on, release the button, the blue light will blink rapidly
indicating that it is in pairing mode.
2. Log in the website, click "Connect to Hub" .
3. After pairing with Hub, choose "Devices" ,then click "Discover
Devices" , Tap "ZigBee" , Choose "Start ZigBee Pairing" .
4. After the pairing is successful, it will shows on page as "Third-
Reality Water Leak Sensor" . Click "Label" ,you can rename the
it and tap save.
5. Go to the Device page, you will see the rename Water Leak
Sensor and click in, you can see the details information.