Third Reality Water Leak Sensor Manual page 6

Pairing with Home Assistant
Pairing Steps:
1. Open the back cover of your Water Leak Sensor with a screw-
driver, insert two AAA batteries, if the blue light is not blinking
rapidly, please press the button for about 3s, when the read
light is on, release the button, the blue light will blink rapidly
indicating that it is in pairing mode.
2. Make sure Home Assistant Integrations ZigBee Home Automa-
tion Setup is ready, then click "+ Add Device" on Device Page.
3. After the pairing is successful, it will show as "Third Reality, Inc
3RSB016BZ" on the page.
4. Back to "Devices & Services" page, click the device list under
the "HubZ Smart Home Controller" button, then you can find
the Motion Sensor added before.
5. You can add "Automated Actions" and check device status
information on the "Device" page.